Clear is best, very light pale yellow next and gold next.  Any other color 
should be
considered as poor quality, particle size too large, stability too low.  If the
choice is between gold and pink, then go for the gold.

Clear is about 1 to 5 or so nm in diameter, light yellow is about 10, gold 
hitting
about 15 I believe.  Anything over 15 is getting too large to absorb in the 
blood
stream, and has stability problems.  clear is best becaue you get lots more
particles per ppm, ie if you double the diameter you get 1/8 the particles for 
the
same ppm, so effectivness vs ppm goes way down when particle size increases, in 
even
considering the ability to be absorbed.

Marshall

Tom Trauberman wrote:

> <<< Even without polarity reversal I very seldom get a yellow color.
> That indicates larger particles size.>>> Is yellow bad? Marshall said
> recently "go for the gold" I notice your spacing and immersion depth is
> alot different than mine. Could this have something to do with the
> difference in your cs and mine?
>
>   Tom
>
>   ------------------------------------------------------------------------
>
> Subject: Re: CS>What the ---?
> Date: Sat, 05 Jun 1999 19:50:48 -0500
> From: [email protected]
> Reply-To: [email protected]
> To: Tom Trauberman <[email protected]>
> References: <[email protected]>
>
> Tom;
>
> I just ran an evaluation batch using 36 vdc, 1" spacing, #14 wire, 3-1/2" in
> water, with ploarity reversal every 60 seconds, 14 oz DW plus 2 oz seed of 10
> ppm.CS.
>
> After 60 min. the ppm = 8.0; after 80 min. the ppm = 11.5 and the CS is
> colorless.  I know the ppm as I measure it with a spectrophotometer.
>
> Even without polarity reversal  I very seldom get a yellow color. That 
> indicates
> larger particles size.
>
> Is there another brand of distilled water available? For me to get yellow I 
> have
> to use deionized, demineralized water.
>
> If I think of anything else I will post it.
>
> Do you have a millampere meter in the circuit to measure the currents? That is
> the quickest way to spot trouble.  A good DW will have an initial current of
> about .26 ma
> with 1" or 1-1/2" spacing and 3-1/2" in water, before adding the seed.
>
> Robert




--
The silver-list is a moderated forum for discussion of colloidal silver.

To join or quit silver-list or silver-digest send an e-mail message to: 
[email protected]  -or-  [email protected]
with the word subscribe or unsubscribe in the SUBJECT line.

To post, address your message to: [email protected]

List maintainer: Mike Devour <[email protected]>