Ode Coyote wrote:
At 02:38 PM 6/13/2008 -0400, you wrote:
Ode Coyote wrote:


The guy splitting water with microwaves didn't reveal how much power
the
microwave emitter  was pulling.
"Publicity stunt" showing only that
thermal cracking of water sorta works and that a microwave can heat up
water,
that hot and that fast if it's big and powerful enough.
..a  Dennis
Lee style "gee whizzer" without a mystery unless the obvious is ignored.
No,
all that was revealed by the lab that duplicated his results. Don't
remember exactly, but the power wasn't that high, around 500 watts I think.

## And the BTU output was what?
If it was any worse than a 24% loss,  it's
still a gee whizzer.


 You'll be needing a lot more [true] info before
even *thinking* about
Scalar energy as a justifiable factor.

Granted, what isn't shown, can't be
true OR un-true...so did that guy lie?

 No, he never mentioned "overunity"
How did overunity get into the
conversation? It may be, but would really
be irrelevant.

## Popping corn in
under 5 seconds with a combined 6-9 watts and scalar waves would be
overunity...more power out than 'people' put in.
6-9 watts over that much area
won't do it at all.

Have you done the math? Electrolysis provides 2.6 CC of hydrogen and 1.3 CC of oxygen per coulomb. For normal electrolysis, the voltage drop is approximately 1.5 volts, so we have a production of 3.9 cc per 1 1/2 watt second, or 2.6 CC per watt second (AKA Joule). I just measured the volume of a popcorn kernel and got about 1/50 of a CC. I would estimate that 1/5 of a CC would be plenty of gas trapped within a volume of 1/50 of a CC to easily pop a kernel (that would provide about 145 psi of pressure without the additional starch inside taking up room, and much much higher with the starch. Thus one watt second of power would theoretically be able to pop about 5*2.6 = 13 pieces of corn, thus 6-9 watts for 5 seconds which would be 30 to 45 watt seconds should have sufficient energy to pop about 390 to 585 kernels of corn. Thus the amount of energy required to pop four kernels during that time is about one percent of the energy being transmitted. This does not even come close to being overunity. How do you figure it would have to be overunity?

Marshall



## OK agreed...mine
tells me if theirs is in the service area or not, if not, it won't connect
and it has to find that out somehow.
Never the less the FCC set a max of 3
watts. "full power"
Most cell phones do 2 watts.

4 watts for a cordless
phone?
What's the point, that is still many times the power needed to do it using disassociation.

Marshall

Ode


Marshall




--
The Silver List is a
moderated forum for discussing Colloidal Silver.

Instructions for
unsubscribing are posted at: http://silverlist.org

To post, address your message
to: [email protected]

Address Off-Topic messages to:
[email protected]

The Silver List and Off Topic List archives are
currently down...

List maintainer: Mike Devour <[email protected]>




No virus found in this incoming message.
Checked by AVG.
Version:
8.0.100 / Virus Database: 270.3.0/1502 - Release Date: 6/13/2008
7:25 PM








--
The Silver List is a moderated forum for discussing Colloidal Silver.

Instructions for unsubscribing are posted at: http://silverlist.org

To post, address your message to: [email protected]

Address Off-Topic messages to: [email protected]

The Silver List and Off Topic List archives are currently down...

List maintainer: Mike Devour <[email protected]>