Ode Coyote wrote:
The guy splitting water with microwaves didn't reveal how much power
the microwave emitter was pulling.
"Publicity stunt" showing only that
thermal cracking of water sorta works and that a microwave can heat up
water, that hot and that fast if it's big and powerful enough.
..a Dennis
Lee style "gee whizzer" without a mystery unless the obvious is ignored.
No, all that was revealed by the lab that duplicated his results. Don't
remember exactly, but the power wasn't that high, around 500 watts I think.
You'll be needing a lot more [true] info before even *thinking* about
Scalar energy as a justifiable factor.
Granted, what isn't shown, can't be
true OR un-true...so did that guy lie?
No, he never mentioned "overunity"
How did overunity get into the conversation? It may be, but would really
be irrelevant.
BTW The FCC sets the parameters that all cell phones use.
It's highly
unlikely that any are significantly different than any other.
Also, they
don't emit a danged thing while they ring...nothing, until you open up
the
circuit by answering.
Actually that is incorrect. The highest power that they transmit is
normally during ringing. There is a lot of hand shaking going on when
it is rigning, and the phone goes to full power at that time to make
sure it all works with no dropouts. Once the connection is made, then
the closest tower and signal loss is identified, the phone switched to
the closest tower, and the power is adjusted downward depending on how
far away the tower is. It is all spelled out in the Q.921 call control
protocol.
Marshall
--
The Silver List is a moderated forum for discussing Colloidal Silver.
Instructions for unsubscribing are posted at: http://silverlist.org
To post, address your message to: silver-list@eskimo.com
Address Off-Topic messages to: silver-off-topic-l...@eskimo.com
The Silver List and Off Topic List archives are currently down...
List maintainer: Mike Devour <mdev...@eskimo.com>
