Hi Marshall, I have noticed a tendency for batches to "go gray" with higher start temps.
How are you measuring the particle size? James Osbourne Holmes [email protected] -----Original Message----- From: Marshall Dudley [SMTP:[email protected]] Sent: Monday, October 04, 1999 11:24 AM To: [email protected] Subject: Re: CS>Particle size/heated water question It is our experience that heating the water results in the motion of the particles being able to overcome the mutual repulsion of the particles and thus leads to aggregation, and larger particle size. That is why we make ours at just above 32 F. I can state for a fact that in our process that if it is made at room temperature or at elevated temperature, the particle size is significantly larger. However our process does differ from the DC process since we are using HVAC and a microflow process. I would think that this would be the same for the DC process, but have not tested it. Marshall Katarina Wittich wrote: > Hey everyone, > I just read Peter Lindemans very interesting article on cs and now I am > confused. > I though that heating water to speed up the process would also increase > particle size. He says "the warmer the water, the faster the reaction will > take place, and the smaller the particles will be". However, he does say > that adding salt to speed up the process does increase particle size. > Can someone explain this to me? Is there a definitive answer about heating > water and particle size? > Thanks, > Katarina > > -- > The silver-list is a moderated forum for discussion of colloidal silver. > > To join or quit silver-list or silver-digest send an e-mail message to: > [email protected] -or- [email protected] > with the word subscribe or unsubscribe in the SUBJECT line. > > To post, address your message to: [email protected] > > List maintainer: Mike Devour <[email protected]>

