Hi Wong, et al I believe there is confusion about who wrote the quotation in the mail to which this is a response.
I am not uncommonly dazed and confused, but I did not write the following: "<< t is our experience that heating the water results in the motion of the particles being able to overcome the mutual repulsion of the particles and thus leads to aggregation, and larger particle size.***" Please check the mail and determine who wrote the above quote and attribute it correctly. Thanks. James Osbourne Holmes [email protected] -----Original Message----- From: [email protected] [SMTP:[email protected]] Sent: Saturday, October 09, 1999 9:53 PM To: [email protected]; Marshall Dudley Subject: Re: CS>Particle size/heated water question Marshall I noticed the "F" after 32 this time. That means you're making CS slightly above freezing, yes? In a message dated 10/04/1999 6:11:22 PM Pacific Daylight Time, [email protected] writes: << t is our experience that heating the water results in the motion of the particles being able to overcome the mutual repulsion of the particles and thus leads to aggregation, and larger particle size. That is why we make ours at just above 32 F. I can state for a fact that in our process that if it is made at room temperature or at elevated temperature, the particle size is significantly larger. However our process does differ from the DC process since we are using HVAC and a microflow process. I would think that this would be the same for the DC process, but have not tested it. >> -- The silver-list is a moderated forum for discussion of colloidal silver. To join or quit silver-list or silver-digest send an e-mail message to: [email protected] -or- [email protected] with the word subscribe or unsubscribe in the SUBJECT line. To post, address your message to: [email protected] List maintainer: Mike Devour <[email protected]>

