Scanning photospectrometer specifically, but often one can visually see it if 
the
particles get large at all by the color.

Marshall

James Osbourne, Holmes wrote:

> Hi Marshall,
>
> I have noticed a tendency for batches to "go gray" with higher start temps.
>
> How are you measuring the particle size?
>
> James Osbourne Holmes
> [email protected]
>
> -----Original Message-----
> From:   Marshall Dudley [SMTP:[email protected]]
> Sent:   Monday, October 04, 1999 11:24 AM
> To:     [email protected]
> Subject:        Re: CS>Particle size/heated water question
>
> It is our experience that heating the water results in the motion of the
> particles being able to overcome the mutual repulsion of the particles and
> thus leads to aggregation, and larger particle size.
>
> That is why we make ours at just above 32 F.  I can state for a fact that in
> our process that if it is made at room temperature or at elevated temperature,
> the particle size is significantly larger.  However our process does differ
> from the DC process since we are using HVAC and a microflow process.  I would
> think that this would be the same for the DC process, but have not tested it.
>
> Marshall
>
> Katarina Wittich wrote:
>
> > Hey everyone,
> > I just read Peter Lindemans very interesting article on cs and now I am
> > confused.
> > I though that heating water to speed up the process would also increase
> > particle size. He says "the warmer the water, the faster the reaction will
> > take place, and the smaller the particles will be". However, he does say
> > that adding salt to speed up the process does increase particle size.
> > Can someone explain this to me? Is there a definitive answer about heating
> > water and particle size?
> > Thanks,
> > Katarina
> >
> > --
> > The silver-list is a moderated forum for discussion of colloidal silver.
> >
> > To join or quit silver-list or silver-digest send an e-mail message to:
> > [email protected]  -or-  [email protected]
> > with the word subscribe or unsubscribe in the SUBJECT line.
> >
> > To post, address your message to: [email protected]
> >
> > List maintainer: Mike Devour <[email protected]>