I wrote that. Marshall
James Osbourne, Holmes wrote: > Hi Wong, et al > > I believe there is confusion about who wrote the quotation in the mail to > which this is a response. > > I am not uncommonly dazed and confused, but I did not write the following: > > "<< t is our experience that heating the water results in the motion of the > particles being able to overcome the mutual repulsion of the particles and > thus leads to aggregation, and larger particle size.***" > > Please check the mail and determine who wrote the above quote and attribute > it correctly. > > Thanks. > > James Osbourne Holmes > [email protected] > > -----Original Message----- > From: [email protected] [SMTP:[email protected]] > Sent: Saturday, October 09, 1999 9:53 PM > To: [email protected]; Marshall Dudley > Subject: Re: CS>Particle size/heated water question > > Marshall > > I noticed the "F" after 32 this time. That means you're making CS slightly > above freezing, yes? > > In a message dated 10/04/1999 6:11:22 PM Pacific Daylight Time, [email protected] > writes: > > << t is our experience that heating the water results in the motion of the > particles being able to overcome the mutual repulsion of the particles and > thus leads to aggregation, and larger particle size. > > That is why we make ours at just above 32 F. I can state for a fact that in > our process that if it is made at room temperature or at elevated > temperature, > the particle size is significantly larger. However our process does differ > from the DC process since we are using HVAC and a microflow process. I would > think that this would be the same for the DC process, but have not tested it. > >> > > -- > The silver-list is a moderated forum for discussion of colloidal silver. > > To join or quit silver-list or silver-digest send an e-mail message to: > [email protected] -or- [email protected] > with the word subscribe or unsubscribe in the SUBJECT line. > > To post, address your message to: [email protected] > > List maintainer: Mike Devour <[email protected]>

