To Jeff and all,

The output of the Bob Beck approved pulsers/
CS makers is 27 VDC (pure DC, no pulsing) if
you use the correct jack (CS).

To limit the current to a maximum of 2 to 3 mA
(depends on how strong you make the CS)
when using 27 or 30 VDC just wire a 8200 ohm
resistor (any wattage will do) in series with one
of the leads going to the silver.

Don't worry about cutting one of the wires to
wire in the resistor and your meter (mA scale).
This will not affect the operation in any way
other than to limit the current (resistor).  The
benefits far outweigh the slight damage (change
of appearance!).

If you still have questions let me know.
Good luck,

Bil





----- Original Message -----
From: Jeffrey A. Madore <[email protected]>
To: <[email protected]>
Sent: Sunday, November 21, 1999 2:33 PM
Subject: Re: CS>Re: Mike/meters


> Hi  Katarina,
>
> The only concern I have in trying to meter the current of the pulser, is
in that
> I'm not sure what the output looks like. If I understand correctly, the
pulser
> changes polarity several (4?) times per second. (I'm looking at a
schematic from Bob
> Beck's site)  This would be equivalent to using a simple setup and
swapping
> the leads to the electrodes 4 times per second.
>
> A DC ammeter connected in line would then see the current change direction
at
> that rate. If the rate of change were slower, the meter would read a
steady state
> positive reading, and then an equal but negative steady state
reading...and so on.
> This is basically a low frequency AC square wave. With the meter set to
DC, it might
> just flash a bunch of numbers at you, as it wouldn't react quickly enough
to display
> the current before it changed direction.
>
> If set to AC, the problem may be similiar, as these meters are usually
designed to
> operate between a range of frequencies, and that doesn't usually extend
down to
> the 2 to 4 Hz range.
>
> Now, looking closer at the schematic in front of me, I'm not certain that
the pulsed
> output is used for silver generation. I'm typing out loud :-)
>
> The schematic I'm looking at has two output jacks: a 3.5mm jack labeled
"biological
> electrification" and an RCA jack labeled "colloids". The output from the
RCA jack
> appears to be fixed polarity DC with no active current limiting. There is
a 150 ohm
> resistor and small lamp in series to limit the short circuit current only.
This output
> would work nicely with a digital multimeter.
>
> So, maybe I'm not even on the right page!!!  I have Lyme Disease and
associated
> dane bramage...keep *that* in mind.
>
> Three things I know for sure:
>
> 1. Mike's idea of getting a multimeter is a good one, as he said, it is a
very useful
>     tool and it will aid in understanding this electrical stuff.
>
> 2. Supper is ready.
>
> 3. The smoke alarms work!
>
> God Bless,
> Jeff
>
>
>
> --
> The silver-list is a moderated forum for discussion of colloidal silver.
>
> To join or quit silver-list or silver-digest send an e-mail message to:
> [email protected]  -or-  [email protected]
> with the word subscribe or unsubscribe in the SUBJECT line.
>
> To post, address your message to: [email protected]
> Silver-list archive: http://escribe.com/health/thesilverlist/index.html
> List maintainer: Mike Devour <[email protected]>
>