Hi Vince,

That's correct.  I assume the conversion numbers they put on the bottle are
for use if you aren't using their PWT with temperature compensation but
using a non-temp compensated device.

I suspect the meter is "hunting" until the temp. compensator levels out when
you immerse it.

Trem



----- Original Message -----
From: "Vince Richter" <[email protected]>
To: <[email protected]>
Sent: Saturday, October 11, 2003 8:28 PM
Subject: [silver_list] CS>PWT operation, was: RE: CS>Measuring very high
ppms


> Thanks, Trem.  That helps a great deal.  So, as I understand it the
> meter senses the temperature, compensates the conductivity reading for
> 77 Degrees, and reads what the solution would be at 77 degrees
> regardless of the solution temp.
>
> One more question:  when I read the conductivity of my CS during
> production, The reading starts out at a peak value, then rapidly drops a
> few uS and then steadies out at a lower value.  What is happening, and
> which reading is right: the initial higher reading, or the final lower
> reading?
>
> Thanks,
>
> Vince
>
> -----Original Message-----
> From: Trem [mailto:[email protected]]
> Sent: Saturday, October 11, 2003 9:27 AM
> To: [email protected]
> Subject: CS>Measuring very high ppms
>
> Hi Vince,
>
> The PWT has a temperature compensator.  The s.s. tube on the left side
> is
> the probe.  So, when calibrating just let it stabilize at whatever
> temperature the solution is and then check the meter to make sure it
> reads
> 84.0 uS.  Make sure you wait until the meter stops "hunting".
>
> Here's the calibration info on the bottle label.  You'll see that 84.0
> uS is
> the reading at 77 F.
>
> °C °F   uS/cm
> 0   32.0   64
> 5   41.0   65
> 10 50.0   67
> 15 59.0   68
> 16 60.8   70
> 17 62.6   71
> 18 64.4   73
> 19 66.2   74
> 20 68.0   76
> 21 69.8   78
> 22 71.6   79
> 23 73.4   81
> 24 75.2   82
> 25 77.0   84
> 26 78.8   86
> 27 80.6   87
> 28 82.4   89
> 29 842   90
> 30 86.0  92
> 31 87.8  94
>
> I hope this helps.
>
> Trem
>
>
>
>
> --
> The silver-list is a moderated forum for discussion of colloidal silver.
>
> Instructions for unsubscribing may be found at: http://silverlist.org
>
> To post, address your message to: [email protected]
>
> Silver-list archive: http://escribe.com/health/thesilverlist/index.html
>
> List maintainer: Mike Devour <[email protected]>
>
>