You can also use the push node.
On Fri, May 24, 2013 at 3:14 PM, Matthew Graves <mattg1...@gmail.com> wrote: > No problem I have included an image of the setup. the scalar number is > what you are adding and SomeArray is the array you want to put the value > in. In the setup shown the new value is added to the bottom of the list > each frame. If you swap the get data and the value it will be added at the > top. > This must be done in a simulated ice tree to work. > [image: Inline image 1] > this is a setup i use quite often. > Matt > > > On Fri, May 24, 2013 at 2:46 PM, Kostas Strevlos <kst...@gmail.com> wrote: > >> Hi Matt thanks for the reply! From your description it seems that this is >> what I am after. I am interested about the simulated version for now. The >> only part that I am not quite sure how to do is the "set it each frame". >> Because as far as remember I used a build array node but it did not keep >> the value for each frame but rather replaced it. So I was left with only >> one value, the current one. Is it possible to explain that part a little >> bit more. >> >> Thanks >> >> Kostas >> >> >> On 24 May 2013 13:17, Matthew Graves <mattg1...@gmail.com> wrote: >> >>> Hi. If you are using a simulated ICE tree you can get an array add the >>> new data to it using the build array node and then set it each frame. this >>> will build a list of lengths upto the current frame. or if its not >>> simulated u can build an array of size=no. of frames and populate it with >>> the lengths from each frame. >>> is this what you are looking for? >>> Matt >>> >> >> >
<<image.jpeg>>