It totally makes sense now! Thanks for the illustration as well. I've seen this sort of set up before but I would have never remembered to use it in this case. Great stuff! Ill have a look at the push node as well.
Thanks again! Kostas On 24 May 2013 16:55, Ciaran Moloney <moloney.cia...@gmail.com> wrote: > You can also use the push node. > > > On Fri, May 24, 2013 at 3:14 PM, Matthew Graves <mattg1...@gmail.com>wrote: > >> No problem I have included an image of the setup. the scalar number is >> what you are adding and SomeArray is the array you want to put the value >> in. In the setup shown the new value is added to the bottom of the list >> each frame. If you swap the get data and the value it will be added at the >> top. >> This must be done in a simulated ice tree to work. >> [image: Inline image 1] >> this is a setup i use quite often. >> Matt >> >> >> On Fri, May 24, 2013 at 2:46 PM, Kostas Strevlos <kst...@gmail.com>wrote: >> >>> Hi Matt thanks for the reply! From your description it seems that this >>> is what I am after. I am interested about the simulated version for now. >>> The only part that I am not quite sure how to do is the "set it each >>> frame". Because as far as remember I used a build array node but it did not >>> keep the value for each frame but rather replaced it. So I was left with >>> only one value, the current one. Is it possible to explain that part a >>> little bit more. >>> >>> Thanks >>> >>> Kostas >>> >>> >>> On 24 May 2013 13:17, Matthew Graves <mattg1...@gmail.com> wrote: >>> >>>> Hi. If you are using a simulated ICE tree you can get an array add the >>>> new data to it using the build array node and then set it each frame. this >>>> will build a list of lengths upto the current frame. or if its not >>>> simulated u can build an array of size=no. of frames and populate it with >>>> the lengths from each frame. >>>> is this what you are looking for? >>>> Matt >>>> >>> >>> >> >
<<image.jpeg>>