Yep and I have even run across 3.5". Usually both that and 3" have 2.5" couplings.
And correct don't use HW. Mfg or the NFPA handbook have methods. Chris -----Original Message----- From: [email protected] Sender: [email protected]: Wed, 6 Apr 2011 16:26:26 To: <[email protected]> Reply-To: [email protected] Subject: RE: HW for hose Never knew there was a 3" hose????Is this a manual wet or dry standpipe?Either way the 500 gpm requirement is at the FDV on the standpipe,unless I have missed something (which is very possible!). Lamar Vaughn,SET On Wed, Apr 6, 2011 at 4:09 PM, Greg McGahan wrote: > If you have to calculate a manual standpipe, what HW coefficient do > you use > for standard fire hoses? > > and what internal diameter is a 3" hose? > > Thanks, > Greg > > -- > Greg McGahan > Living Water Fire Protection, LLC <http://www.livingwaterfp.com> > 1160 McKenzie Road > Cantonment, FL 32533 > 850-937-1850 > fax 850-937-1852 > _______________________________________________ > Sprinklerforum mailing list > [email protected] > http://fireball.firesprinkler.org/mailman/listinfo/sprinklerforum > > For Technical Assistance, send an email to: [email protected] > > To Unsubscribe, send an email > to:[email protected] > (Put the word unsubscribe in the subject field) _______________________________________________ Sprinklerforum mailing list [email protected] http://fireball.firesprinkler.org/mailman/listinfo/sprinklerforum For Technical Assistance, send an email to: [email protected] To Unsubscribe, send an email to:[email protected] (Put the word unsubscribe in the subject field) _______________________________________________ Sprinklerforum mailing list [email protected] http://fireball.firesprinkler.org/mailman/listinfo/sprinklerforum For Technical Assistance, send an email to: [email protected] To Unsubscribe, send an email to:[email protected] (Put the word unsubscribe in the subject field)
