Would it be better to apply heat the metal shell or to apply heat the
bottom part with the I/O pins ?
I would start using a propane gas torch. Heating quickly till I saw the
solder flow.
Stan, W1LE Cape Cod
On 2/9/2012 6:04 AM, Azelio Boriani wrote:
Don't be afraid and open up your MV89. I have done this with many MV201
without problems.
_______________________________________________
time-nuts mailing list -- time-nuts@febo.com
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.