Yes but in that case the core can be hotter then the cables. We don't know about the powder, and the changes of magnetic fields inside the core could stir the powder around and by changing that behavior you might end up controlling the reaction rate. Also inductive heating of an inner containing cylinder does produce a fast response to the actual cylinder which controls the heat radiative environment in there.
On Sun, Oct 12, 2014 at 6:41 PM, Robert Lynn <[email protected] > wrote: > inductive heating only works on conductive materials with sufficient > thickness/area through which the changing magnetic flux passes to allow > eddy currents to form. With 150Hz pulses Nickel particles of tiny scale > would not be affected (like thin motor laminates) - it would only work to > heat a secondary metal body that could then heat via radiation (very > inefficient, and of no practical benefit). > > On 13 October 2014 00:35, Stefan Israelsson Tampe <[email protected] > > wrote: > >> How do we know that iti s resistive heating that is taking place? Bob >> Greenyer at MFMP sugested that it is an inductive heater this means that >> the wires >> get a bit cooler then the heated core. >> >> On Sun, Oct 12, 2014 at 6:24 PM, Robert Lynn < >> [email protected]> wrote: >> >>> Fig 12b. page 26. Only just notice that they say they are "inconel" >>> resistance wires. But how can the resistor wire, external to the reactor, >>> glow more brightly than the reactor itself (implying it is hotter)? Also >>> if the reactor external surface is at 1250-1410°C, then on top of the >>> 30-50°C temperature drop through the walls the resistive wire would have to >>> be even hotter (up towards 1500°C) in order to be able to radiate the >>> 900W! And there are no "inconel" metal wires that can survive such >>> temperatures in air for a month. >>> http://www.engineeringtoolbox.com/melting-temperature-metals-d_860.html >>> >>> There is also a mistake in their discussion for these figures, the metal >>> resistors within the reactor would necessarily have to be hotter than the >>> reactor itself if they are to be able to output heat into the reactor. But >>> then again at >1450°C inconel resistance wires would have turned into >>> puddles anyway. >>> >>> The 2mm high fins on the outside, subjected to convective air cooling >>> would be 30-50°C colder than the base of the fins due to the longer >>> conduction path and hence greater temperature drop through the alumina. >>> And that should influence the thermography to under-read, but also means >>> the temperature within the reactor would have to be even higher to create >>> 1400°C average surface temperature. >>> >>> So this proves that the thermographic temperature readings are off by a >>> very long way - at least 150-200°C too high if inconel wires that max-out >>> at about 1300-1350°C were to have survived for a month. We now know there >>> is a huge error, we just don't know the source of the error, or how big the >>> error is. But eg 1210°C vs 1410°C would drop power output by 40% from that >>> claimed so that the COP would be <2. >>> >>> With the existence of such a huge error of unknown source the claims of >>> power output cannot not be trusted at all. >>> >>> On the upside, it does however mean that the nickel was not melted, and >>> lithium vapour pressure was a lot lower. >>> >> >> >
