Ubiquity has had problems with their CCQ calculations over time, one that that normally will help is limiting the maximum speed.
Regards Michael Baird > CCQ is relatively useless without a lot of traffic moving thru it. > > Regards, > Chuck Hogg > Shelby Broadband > 502-722-9292 > ch...@shelbybb.com > http://www.shelbybb.com > > > -----Original Message----- > From: wireless-boun...@wispa.org [mailto:wireless-boun...@wispa.org] On > Behalf Of RickG > Sent: Monday, February 15, 2010 2:20 PM > To: WISPA General List > Subject: Re: [WISPA] UBNT NS2 > > Same here. I just tweak the power settings until the speed tests get > the best results. I do notice that the CCQ usually comes up after a > while. > -RickG > > On Mon, Feb 15, 2010 at 1:03 PM, Josh Luthman > <j...@imaginenetworksllc.com> wrote: > >> I've always ignored CCQ. I have found no rhyme or reason when comparing it >> to the speed tests or latency to the CPEs. >> >> Josh Luthman >> Office: 937-552-2340 >> Direct: 937-552-2343 >> 1100 Wayne St >> Suite 1337 >> Troy, OH 45373 >> >> "Success is not final, failure is not fatal: it is the courage to continue >> that counts." >> --- Winston Churchill >> >> >> On Mon, Feb 15, 2010 at 12:57 PM, Steve Barnes <st...@pcswin.com> wrote: >> >> >>> I need some advise, I have been using Tranzeo's for years and have some >>> peers that really like the UBNT products so I have picked up a bunch of NS2, >>> NS2loco, and Power Station's. I have had some great results here at first >>> and my installers love them. >>> >>> HOWEVER, the more I watch them the more, I am concerned. I use all MT 411AH >>> with XR2 radios at my AP's. I have a AP with 16 clients, 14 Tranzeo CPQ and >>> 2 NS2. The NS2 (latest install) -55 at radio -69 at tower, the client is 1.9 >>> miles so I set the Mileage @ 2. The client works fine 3 meg down and 1 meg >>> up just as my Queues are set. However, the CCQ at tower for that client is >>> 55tx/72rx. The overall CCQ on the tower when I do speed test to the Tranzeos >>> never falls below 95 but to the UBNT it falls to 75. I have NEVER seen >>> better than a 80/90 CCQ on any of the NS2 or loco. The power stations are >>> great. >>> >>> Is there a config I'm missing. My AP's are all at 10Mhz channels I set the >>> RTS to 512 like I do the Tranzeo's. Rate Algorithm to Optimistic, Allow all >>> multicast data. >>> >>> What else, What am I doing that I should change on the UBNT. >>> >>> >>> Steve Barnes >>> RC-WiFi Wireless Internet Service >>> >>> >>> >>> -------------------------------------------------------------------------------- >>> WISPA Wants You! Join today! >>> http://signup.wispa.org/ >>> >>> -------------------------------------------------------------------------------- >>> >>> WISPA Wireless List: wireless@wispa.org >>> >>> Subscribe/Unsubscribe: >>> http://lists.wispa.org/mailman/listinfo/wireless >>> >>> Archives: http://lists.wispa.org/pipermail/wireless/ >>> >>> >> -------------------------------------------------------------------------------- >> WISPA Wants You! Join today! >> http://signup.wispa.org/ >> -------------------------------------------------------------------------------- >> >> WISPA Wireless List: wireless@wispa.org >> >> Subscribe/Unsubscribe: >> http://lists.wispa.org/mailman/listinfo/wireless >> >> Archives: http://lists.wispa.org/pipermail/wireless/ >> >> > > > -------------------------------------------------------------------------------- > WISPA Wants You! Join today! > http://signup.wispa.org/ > -------------------------------------------------------------------------------- > > WISPA Wireless List: wireless@wispa.org > > Subscribe/Unsubscribe: > http://lists.wispa.org/mailman/listinfo/wireless > > Archives: http://lists.wispa.org/pipermail/wireless/ > > > -------------------------------------------------------------------------------- > WISPA Wants You! Join today! > http://signup.wispa.org/ > -------------------------------------------------------------------------------- > > WISPA Wireless List: wireless@wispa.org > > Subscribe/Unsubscribe: > http://lists.wispa.org/mailman/listinfo/wireless > > Archives: http://lists.wispa.org/pipermail/wireless/ > -------------------------------------------------------------------------------- WISPA Wants You! Join today! http://signup.wispa.org/ -------------------------------------------------------------------------------- WISPA Wireless List: wireless@wispa.org Subscribe/Unsubscribe: http://lists.wispa.org/mailman/listinfo/wireless Archives: http://lists.wispa.org/pipermail/wireless/