Hi David,
On 7/19/2017 11:42 AM, David Tiller wrote:
Using flatten for me results in a very angry red and yellow mess. I run
my input signal fairly hot, though. Around 60dB or so. It seems that
flatten can't handle high input levels.
Almost always, this behavior indicated that you have not followed the
advice for use of *Flatten* in Section 10.7 of the User Guide:
file:///C:/JTSDK/wsjtx/devel/qt55/1.7.1/Release/install/share/doc/WSJT-X/wsjtx-main-1.7.1-devel.html#CONTROLS_WIDE
FYI: this is the sort of message -- one dealing with configuration or
use of WSJT-X -- that fits better on the "wsjtgroup" reflector, rather
than here on "wsjt-devel".
-- 73, Joe, K1JT
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
wsjt-devel mailing list
wsjt-devel@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/wsjt-devel
