When I boot up without the disks in the slots. I manually bring the pool on line with zpool clear <poolname>
I believe that was what you were missing from your command. However I did not try to change controller. Hopefully you only been unplug disks while the system is turn off. If that's case the pool should still be in consistent state. Otherwise, you may want to consider leave the first disk you removed unplug until you bring up the pool on-line then re-add the device back in. (first out last in). Good Luck. -- This message posted from opensolaris.org _______________________________________________ zfs-discuss mailing list zfs-discuss@opensolaris.org http://mail.opensolaris.org/mailman/listinfo/zfs-discuss
