Not following how you are going to use SNMP without a monitoring 
system.Packetflux Sitemonitor can turn a contact closure into a 1 or 0 OID that 
an SNMP monitoring system can check at regular intervals, mine mostly polls 
every 1 minute. But then you would typically have your NMS send an alert by 
email or text message.I tend to monitor analog parameters like voltage or 
current, then set trip points for the NMS to send an informative message. Like 
UPS input voltage at the Podunk site has been below the minimum value of 100 V 
for more than 2 minutes.---- Original Message ----From: "Chuck McCown via AF" 
Sent: 5/8/2024 2:41:36 PMTo: "TJ Trout" , "AnimalFarm Microwave Users Group" 
Cc: chuck@go-mtc.comSubject: Re: [AFMUG] SNMP



So how do Forrest?s products let you know of an issue?? Traps?
?
\Would love to NOT have to have NMS just for this.? 
?


?

From: TJ Trout 

Sent: Wednesday, May 8, 2024 1:35 PM
To: AnimalFarm Microwave Users Group 

Cc: Chuck McCown 
Subject: Re: [AFMUG] SNMP
?

Packet flux can do it all too, the base unit can monitor two voltages and 
temp and a few contact closures, if you need more volt inputs or closures you 
add a expansion unit. No email that I'm aware of
?

On Wed, May 8, 2024, 12:23?PM Chuck McCown via AF 
<af@af.afmug.com> wrote:

  
  
  
  No, we have fuse alarms, rectifier, inverter, and other comm equipment 
  alarm contacts.? Circuit breaker alarms.? That is why historically I 
  liked the netguardian product.? It eats everything.? Monitors DC 
  voltages etc.? Temps
  ?
  ?
  
  
  ?
  
  From: Bill Prince 
  
  Sent: Wednesday, May 8, 2024 1:13 PM
  To: af@af.afmug.com 
  
  Subject: Re: [AFMUG] SNMP
  ?
  
  I think if your installed equipment all came from one vendor, there might 
  be some way to do their proprietary monitoring solution.
  However, SNMP as flawed as it might be, is the only standard that is nearly 
  universal (because some implementations are better than others).
  ?bp
<part15sbs{at}gmail{dot}com>
  On 5/8/2024 11:30 AM, Chuck McCown via AF wrote:
  
    
    
    We are needing to add some monitoring of old fashioned alarm contacts 
    in one of our sites.? In the past I used Netguardians.? Not sure 
    what Forrest has.? 
    ?
    Is SNMP still the defacto NMS comm method or are there better more 
    modern stuff out there we should be looking at?
    ?
    ?
    Best 
    Regards,Chuck McCownMcCown Technology Corporation 8401 N 
    Commerce DrLake Point, Utah 84074801-250-9503 Office435-830-4306 
    Cellwww.mccowntech.comwww.microtrench.prowww.terabitnetworks.com
     
  
  
  -- AF mailing 
listAF@af.afmug.comhttp://af.afmug.com/mailman/listinfo/af_af.afmug.com-- 
  AF mailing 
listAF@af.afmug.comhttp://af.afmug.com/mailman/listinfo/af_af.afmug.com

-- 
AF mailing list
AF@af.afmug.com
http://af.afmug.com/mailman/listinfo/af_af.afmug.com

Reply via email to