What is the gain on those panels?

Josh Luthman wrote:

Sometime...but ITelite has panels now so...

Josh Luthman
Office: 937-552-2340
Direct: 937-552-2343
1100 Wayne St
Suite 1337
Troy, OH 45373

On Mar 13, 2015 9:19 PM, "Jay Weekley" <[email protected] <mailto:[email protected]>> wrote:

    I'm holding my breath for the 2.4 connectorized dish Cambium is
    releasing. Isn't that this month?

    Josh Luthman wrote:


        Remote is coming.

        Are you doing epmp on both bands on the dual band itelite?
        Have you checked signal to make sure 2g carries farther than 5g?

        Josh Luthman
        Office: 937-552-2340u
        Direct: 937-552-2343 <tel:937-552-2343>
        1100 Wayne St
        Suite 1337
        Troy, OH 45373

        On Mar 13, 2015 9:11 PM, "Paul McCall" <[email protected]
        <mailto:[email protected]> <mailto:[email protected]
        <mailto:[email protected]>>> wrote:

            We have mostly been using the Cambium sectors, but just
        started
            using the ITElite model that does both 2.4 and 5 Ghz on same
            sector.  A/B comparison was pretty much identical compared to
            Cambium on the 2.4 Ghz side and slightly stronger on the 5
        Ghz side.

            eDetect has its shortcomings.   It only picks up 801.11
        devices on
            same frequency.    ePMP doesn’t have remote spectrum analyzer
            which would be helpful.   (unless it was just added)

            *From:*Af [mailto:[email protected]
        <mailto:[email protected]>
            <mailto:[email protected]
        <mailto:[email protected]>>] *On Behalf Of *Josh Luthman
            *Sent:* Friday, March 13, 2015 9:04 PM
            *To:* [email protected] <mailto:[email protected]>
        <mailto:[email protected] <mailto:[email protected]>>
            *Subject:* Re: [AFMUG] Any success with 2.4 ePMP?

            Are you using the suggested sectors, Paul?

            Should eDetect see TDD and wifi devices?

            Josh Luthman
            Office: 937-552-2340 <tel:937-552-2340> <tel:937-552-2340
        <tel:937-552-2340>>
            Direct: 937-552-2343 <tel:937-552-2343> <tel:937-552-2343
        <tel:937-552-2343>>
            1100 Wayne St
            Suite 1337
            Troy, OH 45373

            On Mar 13, 2015 8:45 PM, "Paul McCall" <[email protected]
        <mailto:[email protected]>
            <mailto:[email protected] <mailto:[email protected]>>> wrote:

            We have about 250 2.4 SMs deployed with pretty good
        success.     Where we have had some issues are...

            1) direct competitor interference in the band.  It does
        "OK" but
            FSK seemed  to do much better at it, but probably because
        of the
            lesser SNR requirements as much as the modulation.  One
        tower out
            of 10 has this issue for us.
            2) highly concentrated neighborhoods where the neighbors house
            with his wiz-bang overkill home router causes gried.

            TIPS:
            1) Use Mikrotik routers EVERYWHERE, EVERY customer... to
        control
            the 2.4 "local" environment as much as possible, scan for
        problems
            etc.
            2) Be conscious about what Frequency boxes are checked in the
            SMs.  Obviously avoid the frequency you have the router at.
                    If you don't have a second AP that has a good enough
            signal (-65 or less) and the customer is NOT on the edge of a
            sector, you can keep the second frequency checked
                    If you have a poor "second AP" signal OR you have a
            customer installed on a sector edge, check ONLY the one
        frequency
            of the "good" (proper angled) AP

            Doing this, your eDedects will be happy, and you give
        yourself the
            best chance for success.  We actually are writing some SNMP
            backend stuff to help point out problems in all these
        areas, and
            proactively "fix" them

            Paul

            -----Original Message-----
            From: Af [mailto:[email protected]
        <mailto:[email protected]>
            <mailto:[email protected]
        <mailto:[email protected]>>] On Behalf Of George Skorup (Cyber
            Broadcasting)
            Sent: Friday, March 13, 2015 8:29 PM
            To: [email protected] <mailto:[email protected]>
        <mailto:[email protected] <mailto:[email protected]>>
            Subject: Re: [AFMUG] Any success with 2.4 ePMP?

            Haven't even bought any. We're thinking about not even
        buying any more
            2.4 450. It's just too noisy. All the wifi in neighborhoods,
            customer's router interfering with the SM, etc. It's
        pretty much
            as horrible as 900 these days.

            And if we don't get to keep 5.7 ISM.. things are gonna get
        shitty.
            3GHz is the only place to go, so we're gonna be doing a
        bunch more
            of it this year.

            On 3/13/2015 6:48 PM, Josh Luthman wrote:
            > I've heard of several networks having problems with it
        for one
            reason
            > or another, generally the inability to coexist with
        FSK.  Does
            any one
            > network have some success with them?
            >
            > Josh Luthman
            > Office: 937-552-2340 <tel:937-552-2340>
        <tel:937-552-2340 <tel:937-552-2340>>
            > Direct: 937-552-2343 <tel:937-552-2343>
        <tel:937-552-2343 <tel:937-552-2343>>
            > 1100 Wayne St
            > Suite 1337
            > Troy, OH 45373



Reply via email to