Take a look at the Notifications tab and it should tell you what the problem is. A lot of times it may be that you have the power set to high for the frequency or antenna.
On Tue, Apr 21, 2015 at 12:58 PM, Jerry Head <li...@blountbroadband.com> wrote: > Usually when you get the red triangle there is a setting somewhere that > the radio does not like. > Take a look at the network page again and look for errors. > > On 4/21/2015 10:33 AM, SmarterBroadband wrote: > > Rebooted a couple of times... > > > > *From:* Af [mailto:af-boun...@afmug.com <af-boun...@afmug.com>] *On > Behalf Of *Josh Luthman > *Sent:* Tuesday, April 21, 2015 8:14 AM > *To:* af@afmug.com > *Subject:* Re: [AFMUG] ePMP Red Triangle ! > > > > Did you do a firmware upgrade and forget to reboot? > > > > > Josh Luthman > Office: 937-552-2340 > Direct: 937-552-2343 > 1100 Wayne St > Suite 1337 > Troy, OH 45373 > > > > On Tue, Apr 21, 2015 at 11:07 AM, SmarterBroadband < > li...@smarterbroadband.com> wrote: > > On a ePMP running 2.4 software set as an AP (One customer CPE connected) > both radios installed yesterday. On the AP we have a red triangle with an > exclamation mark in it on the Network tab in configuration. The radio will > not let us save changes now, save button grayed out. Radio is operational > and passing traffic. Just want to set MIR profile in AP.... > > > > Any ideas what can cause this? Hoping not to have to go to site and reset > to factory defaults. > > > > Thanks > > > > Adam > > > > >