What are you asking? 20dBm Tx power is the highest it was certified for
because of the OOBE stuff, IIRC. And 14dBm for DFS. The 450 is better
for DFS deployments since you can run max allowed EIRP with an omni. I
have a few extremely small micro-POPs with 450APs and KP omnis in
industrial parks. And one ePMP POP with a KP omni in a residential
neighborhood. They all work well, obviously mostly because of the
extremely low noise floor.
On 4/21/2015 4:53 PM, SmarterBroadband wrote:
Unit is set to 5160. TX power = 20. Antenna Gain = 13.
That raises a good question. Are we not supposed to be able to use
5.8 numbers for PMP and PTP in 5.1?
I.E. 5150-5250 = 36 for non PTP AP. 53 for other modes. (taken from
ePMP user manual)
Adam
*From:*Af [mailto:af-boun...@afmug.com] *On Behalf Of
*can...@believewireless.net
*Sent:* Tuesday, April 21, 2015 10:12 AM
*To:* af@afmug.com
*Subject:* Re: [AFMUG] ePMP Red Triangle !
Take a look at the Notifications tab and it should tell you what the
problem is. A lot of times it may
be that you have the power set to high for the frequency or antenna.
On Tue, Apr 21, 2015 at 12:58 PM, Jerry Head
<li...@blountbroadband.com <mailto:li...@blountbroadband.com>> wrote:
Usually when you get the red triangle there is a setting somewhere
that the radio does not like.
Take a look at the network page again and look for errors.
On 4/21/2015 10:33 AM, SmarterBroadband wrote:
Rebooted a couple of times�
*From:*Af [mailto:af-boun...@afmug.com] *On Behalf Of *Josh Luthman
*Sent:* Tuesday, April 21, 2015 8:14 AM
*To:* af@afmug.com <mailto:af@afmug.com>
*Subject:* Re: [AFMUG] ePMP Red Triangle !
Did you do a firmware upgrade and forget to reboot?
Josh Luthman
Office: 937-552-2340 <tel:937-552-2340>
Direct: 937-552-2343 <tel:937-552-2343>
1100 Wayne St
Suite 1337
Troy, OH 45373
On Tue, Apr 21, 2015 at 11:07 AM, SmarterBroadband
<li...@smarterbroadband.com <mailto:li...@smarterbroadband.com>>
wrote:
On a ePMP running 2.4 software set as an AP (One customer CPE
connected) both radios installed yesterday. On the AP we have a
red triangle with an exclamation mark in it on the Network tab in
configuration. The radio will not let us save changes now, save
button grayed out. Radio is operational and passing traffic.
Just want to set MIR profile in AP�.
Any ideas what can cause this? Hoping not to have to go to site
and reset to factory defaults.
Thanks
Adam
