On that note there was a bug in 2.3.4 (may still be around, not sure) that would let you select a higher tx power than you could get away with. It would save and look all happy. However, if you look at the status tab it would be 0tx because you were trying excessive EIRP.
Josh Luthman Office: 937-552-2340 Direct: 937-552-2343 1100 Wayne St Suite 1337 Troy, OH 45373 On Tue, Apr 21, 2015 at 1:12 PM, can...@believewireless.net < p...@believewireless.net> wrote: > Take a look at the Notifications tab and it should tell you what the > problem is. A lot of times it may > be that you have the power set to high for the frequency or antenna. > > On Tue, Apr 21, 2015 at 12:58 PM, Jerry Head <li...@blountbroadband.com> > wrote: > >> Usually when you get the red triangle there is a setting somewhere that >> the radio does not like. >> Take a look at the network page again and look for errors. >> >> On 4/21/2015 10:33 AM, SmarterBroadband wrote: >> >> Rebooted a couple of times… >> >> >> >> *From:* Af [mailto:af-boun...@afmug.com <af-boun...@afmug.com>] *On >> Behalf Of *Josh Luthman >> *Sent:* Tuesday, April 21, 2015 8:14 AM >> *To:* af@afmug.com >> *Subject:* Re: [AFMUG] ePMP Red Triangle ! >> >> >> >> Did you do a firmware upgrade and forget to reboot? >> >> >> >> >> Josh Luthman >> Office: 937-552-2340 >> Direct: 937-552-2343 >> 1100 Wayne St >> Suite 1337 >> Troy, OH 45373 >> >> >> >> On Tue, Apr 21, 2015 at 11:07 AM, SmarterBroadband < >> li...@smarterbroadband.com> wrote: >> >> On a ePMP running 2.4 software set as an AP (One customer CPE connected) >> both radios installed yesterday. On the AP we have a red triangle with an >> exclamation mark in it on the Network tab in configuration. The radio will >> not let us save changes now, save button grayed out. Radio is operational >> and passing traffic. Just want to set MIR profile in AP…. >> >> >> >> Any ideas what can cause this? Hoping not to have to go to site and >> reset to factory defaults. >> >> >> >> Thanks >> >> >> >> Adam >> >> >> >> >> >