Unit is set to 5160. TX power = 20. Antenna Gain = 13.
That raises a good question. Are we not supposed to be able to use 5.8 numbers for PMP and PTP in 5.1? I.E. 5150-5250 = 36 for non PTP AP. 53 for other modes. (taken from ePMP user manual) Adam From: Af [mailto:af-boun...@afmug.com] On Behalf Of can...@believewireless.net Sent: Tuesday, April 21, 2015 10:12 AM To: af@afmug.com Subject: Re: [AFMUG] ePMP Red Triangle ! Take a look at the Notifications tab and it should tell you what the problem is. A lot of times it may be that you have the power set to high for the frequency or antenna. On Tue, Apr 21, 2015 at 12:58 PM, Jerry Head <li...@blountbroadband.com> wrote: Usually when you get the red triangle there is a setting somewhere that the radio does not like. Take a look at the network page again and look for errors. On 4/21/2015 10:33 AM, SmarterBroadband wrote: Rebooted a couple of times. From: Af [mailto:af-boun...@afmug.com] On Behalf Of Josh Luthman Sent: Tuesday, April 21, 2015 8:14 AM To: af@afmug.com Subject: Re: [AFMUG] ePMP Red Triangle ! Did you do a firmware upgrade and forget to reboot? Josh Luthman Office: 937-552-2340 Direct: 937-552-2343 1100 Wayne St Suite 1337 Troy, OH 45373 On Tue, Apr 21, 2015 at 11:07 AM, SmarterBroadband <li...@smarterbroadband.com> wrote: On a ePMP running 2.4 software set as an AP (One customer CPE connected) both radios installed yesterday. On the AP we have a red triangle with an exclamation mark in it on the Network tab in configuration. The radio will not let us save changes now, save button grayed out. Radio is operational and passing traffic. Just want to set MIR profile in AP.. Any ideas what can cause this? Hoping not to have to go to site and reset to factory defaults. Thanks Adam
