Thanks! --
From: Jeremy Reply-To: "af@afmug.com<mailto:af@afmug.com>" Date: Wednesday, May 13, 2015 at 8:58 PM To: "af@afmug.com<mailto:af@afmug.com>" Subject: Re: [AFMUG] Airfiber 24 weird issue Absolutely. It will not work without it. On Wed, May 13, 2015 at 6:56 PM, Andreas Wiatowski <andr...@silowireless.com<mailto:andr...@silowireless.com>> wrote: Out of curiosity…should I be turning on GPS timing? Does it even work? -- From: Josh Reynolds Reply-To: "af@afmug.com<mailto:af@afmug.com>" Date: Wednesday, May 13, 2015 at 8:49 PM To: "af@afmug.com<mailto:af@afmug.com>" Subject: Re: [AFMUG] Airfiber 24 weird issue Make both airfibers on the shared rooftop masters, with reversed tx/rx. I think the most we have at one location is 4, and there is no more than 10 feet from end to end of the structure. They are on slightly different azimuths. Josh Reynolds CIO, SPITwSPOTS www.spitwspots.com<http://www.spitwspots.com> On 05/13/2015 04:46 PM, Andreas Wiatowski wrote: We have 2 Airfiber 24’s co-located on a building rooftop… they have about 15ft horizontal separation. The one air fibre pair is aimed at a tower about 1KM away and not the tower side we are about 75ft in the air. The other Airfiber is located on a building across the road at the same height. The azimuth is about 15 degrees off of each other. The link from roof to tower, works 100%. The link from building to building is about 400ft away and we are having weird issues getting it to link. Is there some sort of co-location magic to make this work? I read somewhere that we should have master or slave mode matching at the co-located sites. Any words of wisdom are appreciated. -Andreas --
