Are you doing half or full duplex?
On 5/13/2015 8:02 PM, Andreas Wiatowski wrote:
Thanks!
--
From: Jeremy
Reply-To: "af@afmug.com <mailto:af@afmug.com>"
Date: Wednesday, May 13, 2015 at 8:58 PM
To: "af@afmug.com <mailto:af@afmug.com>"
Subject: Re: [AFMUG] Airfiber 24 weird issue
Absolutely. It will not work without it.
On Wed, May 13, 2015 at 6:56 PM, Andreas Wiatowski
<andr...@silowireless.com <mailto:andr...@silowireless.com>> wrote:
Out of curiosity…should I be turning on GPS timing? Does it even
work?
--
From: Josh Reynolds
Reply-To: "af@afmug.com <mailto:af@afmug.com>"
Date: Wednesday, May 13, 2015 at 8:49 PM
To: "af@afmug.com <mailto:af@afmug.com>"
Subject: Re: [AFMUG] Airfiber 24 weird issue
Make both airfibers on the shared rooftop masters, with reversed
tx/rx. I think the most we have at one location is 4, and there is
no more than 10 feet from end to end of the structure. They are on
slightly different azimuths.
Josh Reynolds
CIO, SPITwSPOTS
www.spitwspots.com <http://www.spitwspots.com>
On 05/13/2015 04:46 PM, Andreas Wiatowski wrote:
We have 2 Airfiber 24’s co-located on a building rooftop… they
have about 15ft horizontal separation. The one air fibre pair is
aimed at a tower about 1KM away and not the tower side we are
about 75ft in the air. The other Airfiber is located on a
building across the road at the same height. The azimuth is
about 15 degrees off of each other. The link from roof to tower,
works 100%. The link from building to building is about 400ft
away and we are having weird issues getting it to link. Is there
some sort of co-location magic to make this work? I read
somewhere that we should have master or slave mode matching at
the co-located sites.
Any words of wisdom are appreciated.
-Andreas
--
