Sandstone probably has poetry low break strength. We used to put small slabs in advance and then use the bolt on base. You could obviously or something in place.
On Wed, Nov 11, 2015, 7:02 PM Jaime Solorza <[email protected]> wrote: > Sas > > Jaime Solorza > On Nov 11, 2015 5:36 PM, "Ken Hohhof" <[email protected]> wrote: > >> Jaime, if they sold Hilti underwear, you’d probably have a drawer full. >> >> Might be more likely to find a brand like Strong-Tie in a home store: >> https://www.youtube.com/watch?v=4Udp1Xqp2Ns >> >> But actually I see Hilti chemical anchors on the Home Depot website as >> well. >> >> >> *From:* Jaime Solorza <[email protected]> >> *Sent:* Wednesday, November 11, 2015 6:11 PM >> *To:* Animal Farm <[email protected]> >> *Subject:* Re: [AFMUG] Sandstone >> >> we used those on a tower located on small mountain....the hard part was >> lugging the generator and fuel for hammer drill. ....I believe Hilti sell >> those epoxy anchors... >> >> Jaime Solorza >> Wireless Systems Architect >> 915-861-1390 >> >> On Wed, Nov 11, 2015 at 4:49 PM, Ken Hohhof <[email protected]> wrote: >> >>> I haven’t faced that problem, but I believe they make a non-pen mount >>> for Rohn 25G. If the sandstone is flat and level, could you use a non-pen >>> and rather than (or in addition to) cinder blocks, fasten the corners to >>> the sandstone with masonry anchors? If you don’t trust traditional >>> anchors, I know there are epoxy anchoring systems available for concrete. >>> >>> *From:* [email protected] >>> *Sent:* Wednesday, November 11, 2015 5:04 PM >>> *To:* [email protected] >>> *Subject:* Re: [AFMUG] Sandstone >>> >>> Dig a hole in the sandstone and cement in a base section. >>> >>> *From:* Randy Cosby <[email protected]> >>> *Sent:* Wednesday, November 11, 2015 3:51 PM >>> *To:* [email protected] >>> *Subject:* [AFMUG] Sandstone >>> >>> >>> Anyone have any experience or tips for putting up small (20’) Rown >>> towers on sandstone? >>> >>> >>> >>> Don’t? :) >>> >>> >>> >>> >>> >> >> >
