I booted up in Dec and accessed the rc.conf file via https://192.168.101.1 just fine. Now after searching extensively and doing much reading, I boot up and cannot access that same point. I had added a 2nd NIC, so I removed it but still no go. So I switched to the other one, but still no go.
I ran ifconfig: every thing seems ok except for the RX packets are 0 in eth0. There are RX bytes being reported in eth0. Is eth0 working ? I tried pinging with dotted addresses, but could only get network unreachable. I would include the ifconfig but the astlinux machine is in basement. Until I learn to mount something and save, I'll have to wait a bit. After about 2-4 minutes there is message: NETDEV WATCHDOG: eth0 transmit timeout. Then nearly a whole screen full of info comes out. 5 or so minutes later it does it again. Here are the two card descriptions: 3Com 3CSOHO100-TX Office Connect Fast Ethernet 3Com 3C595-TX Fast EtherLink PCI Both are 10/100 One of these two card worked in Dec with the CD I setup from the ISO file. I am using the same CD now. Are these cards sensitve to WHICH pci slot they are plugged into ? I guess I will try that idea in the meanwhile.... Rich Sias _______________________________________________ Astlinux-users mailing list [email protected] http://lists.kriscompanies.com/mailman/listinfo/astlinux-users Donations to support AstLinux are graciously accepted via PayPal to [EMAIL PROTECTED]
