Hi Acee, Please observe that this draft defines encoding for SAFI 129 with IPv6 as next hop.
If we are prepend it with zero pls do not forget to also submit the errata to RFC 6514 which says clearly in section 9.2.3.2 that next hop *field* must be set to a routable IP address. Not part of the Next Hop field but the entire *field*. When re-advertising an Inter-AS I-PMSI A-D route, the ASBR MUST set the Next Hop field of the MP_REACH_NLRI attribute to a routable IP address of the ASBR. And the above is just the tip of the iceberg :) Bottom line is that instead of publishing the spec which in backwards compatible fashion allows gradually to fix the implementation errors of the past it is just blessing them. And we all agree that pushing to each MP_REACH NH field 64 zeros is completely unnecessary. Not a good thing in my measures. Best, R. PS. And what happens if those 8 octets is not zeros but zero and ones ? Should it be accepted and ignored or is this an invalid attribute ? On Mon, Dec 2, 2019 at 11:21 PM Acee Lindem (acee) <a...@cisco.com> wrote: > Robert, > > > > What you’re suggesting doesn’t really solve the problem that all the > currently deployed routers that do not follow RFC 5549. No known > implementations follow RFC 5549. Were you on the meetecho when this was > presented in the BESS meeting at IETF 106? There was clear consensus in the > meeting. > > > > Anyway, you can put your ideas in a new draft and let them stand on their > own merit. That way, if there were consensus, we could save those 8 bytes > of RD. However, we shouldn’t mix this with the draft revising RFC 5549 to > reflect the current implementations and deployments. > > > > Thanks, > > Acee > > > > *From: *BESS <bess-boun...@ietf.org> on behalf of Robert Raszuk < > rob...@raszuk.net> > *Date: *Thursday, November 28, 2019 at 11:58 AM > *To: *"slitkows.i...@gmail.com" <slitkows.i...@gmail.com> > *Cc: *"Bocci, Matthew (Nokia - GB)" <matthew.bo...@nokia.com>, " > bess-cha...@ietf.org" <bess-cha...@ietf.org>, "bess@ietf.org" < > bess@ietf.org> > *Subject: *Re: [bess] WG Adoption and IPR Poll for > draft-litkowski-bess-rfc5549revision-00 > > > > Stephane, > > > > Adding ability to recognize the length of the next hop to any code is > purely incremental thing. When vendors were asked I do not even recall if > there was a question if given implementation can infer next hop format from > length or not - and that is the key problem/point here. > > > > Just asking if you are prepending zeros or not to NH in some SAFIs and > stating that if so you do revise 5549 to reflect that is not what we should > be doing. > > > > The main reason is that as SAFIs are being defined every now and then and > there is still no clear document if next hop should match NLRI type or not. > Moreover 4364 is still being developed in few vendors. Sure they want to be > backwards compatible too, but with that let's also give them a chance to do > the right thing vs just follow legacy. > > > > So yes if you are opening that box my suggestion is to define an > additional capability indicating if receiver can process next hop without > any additional nonsense zero padding. All it takes is one paragraph/section > and one IANA codepoint. > > > > Stating that this should be new separate document again updating 5549 and > now 5549revised is really not the best option. > > > > Best, > > Robert > > > > On Thu, Nov 28, 2019 at 5:40 PM <slitkows.i...@gmail.com> wrote: > > Hi Robert, > > > > Please see some replies inline. > > > > Brgds, > > > > *From:* Robert Raszuk <rob...@raszuk.net> > *Sent:* mercredi 27 novembre 2019 22:18 > *To:* Bocci, Matthew (Nokia - GB) <matthew.bo...@nokia.com > <matthew..bo...@nokia.com>> > *Cc:* bess@ietf.org; bess-cha...@ietf.org > *Subject:* Re: [bess] WG Adoption and IPR Poll for > draft-litkowski-bess-rfc5549revision-00 > > > > *I do not support this draft in the current form. * > > > > This document instead of improving the original specification makes it > actually worse. > > [SLI] > > > > Point 1 - > > > > Original RFC sec. 6.2: > > > o Network Address of Next Hop = IPv6 address of Next Hop > > > > Proposed text: > > > > o Network Address of Next Hop = VPN-IPv6 address of Next Hop whose > > RD is set to zero > > > > > > As it has been explained when you negotiate in capability AFI2 as next hop > it is just 16 octets - not 24. > > [SLI] AFI2 means that the nexthop is encoded with a format compliant with > an AFI2, but does not tell anything about the SAFI. A VPN-IPv6 address is > still AFI2. > > > > Next hop never has an RD. > > [SLI] We have already discussed about that. RD doesn’t make any sense for > a nexthop address. No one disagrees on that point. However our legacy > 2547bis introduced a nexthop encoded as a VPN-IP address, and all VPN > unicast SAFIs are following this. As RD does not make sense, zeroes are > just added to fit the size of the address format. In reality, it is just an > IP address with 0es padded before. Of course, it would have been cleaner > to use only a regular IP address instead of a VPN-IP address but again > that’s our legacy. > > > > The fact that some implementations are matching length of NLRI with length > of next hop no where should be made equal that next hop has 8 octet dummy > Route Distinguisher. > > [SLI] Again this is coming from legacy. > > > > > > If revision is to be made would be to explicitly negotiate capability to > infer next hop encoding from the length. > > [SLI] Are you talking about a new capability or the existing ENH cap ? ENH > tells you what is the NH AFI, so the only length check required is for the > case of one or two IPv6 addresses. A new cap means a new solution, and > that’s not the goal here. > > > > > > Point 2 - > > > > Addition of section 6.3 and SAFI 129 is fine, but again next hop encoding > is lightly stating suboptimal. > > > > Conclusion: > > > > As we have discussed on and off line if revision is to be made let's make > it both backwards compatible, Let's make it applicable to both IPv4 and > IPv6 next hop addresses and let's allow explicit capability where > implementations could indicate that it can recognize next hop value from > its length. After all we are talking about just 4 discrete possible values > here. > > [SLI] The goal is not to create something new here, but just to reflect > how RFC5549 has been implemented for the SAFI 128/129 cases. The goal is > also to minimize running code changes too (and even avoid !).. We have to > deal with what has been shipped and deployed by vendors today. We can still > create something completely new, with a new cap and new procedures, but I > think this is orthogonal to “aligning RFC5549 with implementations” as > RFC5549 is there anyway and we can’t blindly forget it due to the codes > that are available. > > > > > > > > Cheers, > > Robert. > > > > > > > > > > > > > > > > > > > > On Wed, Nov 27, 2019 at 1:36 PM Bocci, Matthew (Nokia - GB) < > matthew.bo...@nokia.com> wrote: > > Hello, > > > > This email begins a two-weeks WG adoption poll for > draft-litkowski-bess-rfc5549revision-00 [1] . > > > > Please review the draft and post any comments to the BESS working group > list. > > > > We are also polling for knowledge of any undisclosed IPR that applies to > this Document, to ensure that IPR has been disclosed in compliance with > IETF IPR rules (see RFCs 3979, 4879, 3669 and 5378 for more details). > > > > If you are listed as an author or a contributor of this document, please > respond to this email and indicate whether or not you are aware of any > relevant undisclosed IPR, copying the BESS mailing list. The document won't > progress without answers from all the authors and contributors. > > > > Currently, there are no IPR disclosures against this document. > > > > If you are not listed as an author or a contributor, then please > explicitly respond only if you are aware of any IPR that has not yet been > disclosed in conformance with IETF rules. > > > > This poll for adoption closes on Wednesday 11th December 2019.. > > > > Regards, > > Matthew > > > > [1] https://datatracker.ietf.org/doc/draft-litkowski-bess-rfc5549revision/ > <https://datatracker.ietf..org/doc/draft-litkowski-bess-rfc5549revision/> > > > > > > > > _______________________________________________ > BESS mailing list > BESS@ietf.org > https://www.ietf.org/mailman/listinfo/bess > >
_______________________________________________ BESS mailing list BESS@ietf.org https://www.ietf.org/mailman/listinfo/bess
