As I stated its playing that file ... On 4/17/10, Ashar Siddiqui <siddas...@gmail.com> wrote: > Check that you have correct file name under telephony service/fallback i.e. > > moh music-on-hold.au > multicast moh blah blah > > > On 18/04/2010 01:24, CCIETalk.com wrote: >> Thanks Ashar. I have my own rack and even though I hear the music on >> hold from the flash "piano music" my show ccm manager command won't >> show any output and hence the question :) >> >> On 4/17/10, Ashar Siddiqui<siddas...@gmail.com> wrote: >> >>> Put who on hold? >>> If you put PSTN on hold that would work fine but if you put IP phones of >>> other sites on Hold then they will not hear anything. >>> This is because IPsec limitations over VPN (this is also mentioned at >>> Proctor labs login page). >>> >>> To check if your MOH is working fine then you can run the folliwng >>> commands and check the outputs. >>> These are the outputs I can see for my BR1 MOH: >>> >>> >>> BR1-RTR#sh ccm-manager mus >>> BR1-RTR#sh ccm-manager music-on-hold >>> Current active multicast sessions : 1 >>> Multicast RTP port Packets Call Codec Incoming >>> Address number in/out id Interface >>> =================================================================== >>> 239.1.1.1 16384 433/433 69 g711ulaw Lo0 >>> BR1-RTR# >>> BR1-RTR# >>> BR1-RTR# >>> BR1-RTR#debug eph >>> BR1-RTR#debug ephone moh >>> EPHONE music-on-hold debugging is enabled >>> BR1-RTR# >>> BR1-RTR# >>> Apr 18 00:01:32.241: MoH route If Loopback0 46 10.10.110.2 via >>> 10.10.110.2 >>> Apr 18 00:01:32.241: MoH route If Vlan240 ETHERNET 10.10.201.1 via ARP >>> BR1-RTR# >>> Apr 18 00:01:37.533: MoH route If Loopback0 46 10.10.110.2 via >>> 10.10.110.2 >>> Apr 18 00:01:37.533: MoH route If Vlan240 ETHERNET 10.10.201.1 via ARP >>> BR1-RTR#sh ip mr >>> BR1-RTR#sh ip mro >>> Apr 18 00:01:42.845: MoH route If Loopback0 46 10.10.110.2 via >>> 10.10.110.2 >>> Apr 18 00:01:42.845: MoH route If Vlan240 ETHERNET 10.10.201.1 via ARP >>> BR1-RTR#sh ip mrou >>> BR1-RTR#sh ip mroute >>> IP Multicast Routing Table >>> Flags: D - Dense, S - Sparse, B - Bidir Group, s - SSM Group, C - >>> Connected, >>> L - Local, P - Pruned, R - RP-bit set, F - Register flag, >>> T - SPT-bit set, J - Join SPT, M - MSDP created entry, >>> X - Proxy Join Timer Running, A - Candidate for MSDP >>> Advertisement, >>> U - URD, I - Received Source Specific Host Report, >>> Z - Multicast Tunnel, z - MDT-data group sender, >>> Y - Joined MDT-data group, y - Sending to MDT-data group, >>> V - RD& Vector, v - Vector >>> Outgoing interface flags: H - Hardware switched, A - Assert winner >>> Timers: Uptime/Expires >>> Interface state: Interface, Next-Hop or VCD, State/Mode >>> >>> (*, 239.1.1.1), 00:03:20/00:02:25, RP 0.0.0.0, flags: DCL >>> Incoming interface: Null, RPF nbr 0.0.0.0 >>> Outgoing interface list: >>> Vlan240, Forward/Dense, 00:00:35/00:00:00 >>> >>> (*, 224.0.1.40), 08:48:14/00:02:24, RP 0.0.0.0, flags: DCL >>> Incoming interface: Null, RPF nbr 0.0.0.0 >>> Outgoing interface list: >>> Vlan240, Forward/Dense, 08:48:14/00:00:00 >>> >>> BR1-RTR# >>> Apr 18 00:01:48.081: MoH route If Loopback0 46 10.10.110.2 via >>> 10.10.110.2 >>> Apr 18 00:01:48.081: MoH route If Vlan240 ETHERNET 10.10.201.1 via ARP >>> BR1-RTR# >>> Apr 18 00:01:53.417: MoH route If Loopback0 46 10.10.110.2 via >>> 10.10.110.2 >>> Apr 18 00:01:53.417: MoH route If Vlan240 ETHERNET 10.10.201.1 via ARP >>> BR1-RTR# >>> Apr 18 00:01:58.729: MoH route If Loopback0 46 10.10.110.2 via >>> 10.10.110.2 >>> Apr 18 00:01:58.729: MoH route If Vlan240 ETHERNET 10.10.201.1 via ARP >>> Apr 18 00:01:59.429: ifs_read flash:music-on-hold.au end of file at >>> 492254 read 4267 = 496521 >>> Apr 18 00:01:59.433: moh tail fill from 24 at 0x4A7BFC27 length 3733 >>> BR1-RTR# >>> BR1-RTR# >>> BR1-RTR# >>> BR1-RTR#sh ccm-manager music-on-hold >>> Current active multicast sessions : 1 >>> Multicast RTP port Packets Call Codec Incoming >>> Address number in/out id Interface >>> =================================================================== >>> 239.1.1.1 16384 2833/2833 69 g711ulaw Lo0 >>> BR1-RTR# >>> >>> On 17/04/2010 23:01, CCIETalk.com wrote: >>> >>>> So working through IPX Labs I ran into this. I can hear the "Piano" >>>> music on my BR1 phones when I put them on hold but what will be >>>> another way of testing this? >>>> >>>> -- >>>> www.ccietalk.com<http://www.ccietalk.com> >>>> >>>> >>>> _______________________________________________ >>>> For more information regarding industry leading CCIE Lab training, >>>> please >>>> visit www.ipexpert.com >>>> >>>> >>> >>> -- >>> Thanks, >>> Ashar Siddiqui >>> >>> >>> >> > > > -- > Thanks, > Ashar Siddiqui > >
-- Sent from my mobile device www.ccietalk.com _______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com