That's kind of what I thought. I will be able to move it over to the FE port soon.
So on the config for the shaping command, I create the class, match anything, create the policy, assign the class, and enter the shape command: bandwidth 10M shape peak 13M (this should not allow any more bandwidth than 13M through?) and then on the interface enter in bandwidth 10M Sound right? Thanks, Dan. On Fri, Apr 25, 2008 at 1:28 AM, Oliver Boehmer (oboehmer) <[EMAIL PROTECTED]> wrote: > The ports on the HWIC-4ESW (as well as on the other other switch modules > for the ISRs) generally don't support the same set of QoS features as > the "regular" L3 interfaces, so you can't shape on these ports. Can you > move your uplink to one of the built-in FE ports instead? > > oli > > Dan Letkeman <> wrote on Friday, April 25, 2008 2:37 AM: > > > > > Luan, > > > > I have tried this, but it doesn't seem to take effect. My connection > > is on an HWIC-4ESW. Could that be a problem? If I use "police cir > > 10000000" it works and seems to take effect. > > > > Thanks, > > Dan. > > > > On Thu, Apr 24, 2008 at 7:27 PM, Luan Nguyen > > <[EMAIL PROTECTED]> wrote: > >> I would say you need to use CBWFQ for this. > >> Create an ACL match everything or whatever interested you out of your > >> network and assigned to a class-map, then create a policy map > >> policy-map out > >> class out > >> bandwidth 10M > >> shape peak 13M > >> interface WAN > >> service out out > >> > >> -lmn > >> > >> > >> > >> On Thu, Apr 24, 2008 at 6:48 PM, Dan Letkeman > >> <[EMAIL PROTECTED]> wrote: > >> > >>> > >>> > >>> > >>> Bizarre response..... It just so happens that it's a shared > >>> connection and there is more than 10 available now, and will be > >>> getting 20+ in the future. > >>> > >>> :) > >>> > >>> On Thu, Apr 24, 2008 at 5:23 PM, Adam Armstrong <[EMAIL PROTECTED]> > >>> wrote: > >>> > >>>> > >>>> Dan Letkeman wrote: > >>>> > >>>>> Hello, > >>>>> > >>>>> We have changed our internet connection over from 4 dsl lines to > >>>>> one connection. We have a 25mbit connection provided by a > >>>>> neighboring company and we have an agreement with them that we > >>>>> will only use 10mbit bursting to 12 or 13mbit. What would I need > >>>>> to do on our 2801 to limit our bandwidth to 10 bursting to 13? > >>>>> > >>>>> > >>>> What a bizarre arrangement! If you had just taken 10mbit you > >>>> could have just done "speed 10" :) > >>>> > >>>> adam. > >>> > >>> > >>> > >>>> > >>> > >>> _______________________________________________ > >>> cisco-nsp mailing list [email protected] > >>> https://puck.nether.net/mailman/listinfo/cisco-nsp > >>> archive at http://puck.nether.net/pipermail/cisco-nsp/ > >>> > >> > >> > > _______________________________________________ > > cisco-nsp mailing list [email protected] > > https://puck.nether.net/mailman/listinfo/cisco-nsp > > archive at http://puck.nether.net/pipermail/cisco-nsp/ > _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
