Hi.
You need use dialer interface or dialer profile.
Ls4577
""Louie Belt"" <[EMAIL PROTECTED]> wrote in message
000201c03e40$f4fbb6e0$[EMAIL PROTECTED]">news:000201c03e40$f4fbb6e0$[EMAIL PROTECTED]...
> While configuring and OSPF demand circuit over ISDN, I noticed that the
ISDN
> link would disconnected and immediately reconnect - because the change in
> ospf topology was triggering and LSA flood - forcing the ISDN line to
> reconnect. However, the dialer enable-timeout setting was at it's default
> of 15 seconds so the ISDN link should have been forced to wait 15 seconds
> before attempting to reconnect (and thereby giving the LSA flood time to
> pass). However, this did not happen. No matter what I set the dialer
> enable-timeout to, the redial happened immediately.
>
> Question: What am I missing? (or mis-understanding)
>
> Thanks in advance!
>
> Louie
>
>
>
>
>
>
> _________________________________
> FAQ, list archives, and subscription info:
http://www.groupstudy.com/list/cisco.html
> Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
>
_________________________________
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
