Can you send output of "show ip ospf inte bri" command ,of your router + the
running config o/p
Thanks
Thangavel
----- Original Message -----
From: Sam LI <[EMAIL PROTECTED]>
To: Louie Belt <[EMAIL PROTECTED]>; <[EMAIL PROTECTED]>
Sent: Wednesday, October 25, 2000 5:07 AM
Subject: Re: OSPF Demand Circuit...
> Louie
>
> what is missing, your configuration
>
> Sam Li
> ----- Original Message -----
> From: Louie Belt <[EMAIL PROTECTED]>
> To: <[EMAIL PROTECTED]>
> Sent: Wednesday, October 25, 2000 1:03 PM
> Subject: OSPF Demand Circuit...
>
>
> > While configuring and OSPF demand circuit over ISDN, I noticed that the
> ISDN
> > link would disconnected and immediately reconnect - because the change
in
> > ospf topology was triggering and LSA flood - forcing the ISDN line to
> > reconnect. However, the dialer enable-timeout setting was at it's
default
> > of 15 seconds so the ISDN link should have been forced to wait 15
seconds
> > before attempting to reconnect (and thereby giving the LSA flood time to
> > pass). However, this did not happen. No matter what I set the dialer
> > enable-timeout to, the redial happened immediately.
> >
> > Question: What am I missing? (or mis-understanding)
> >
> > Thanks in advance!
> >
> > Louie
> >
> >
> >
> >
> >
> >
> > _________________________________
> > FAQ, list archives, and subscription info:
> http://www.groupstudy.com/list/cisco.html
> > Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
> >
>
> _________________________________
> FAQ, list archives, and subscription info:
http://www.groupstudy.com/list/cisco.html
> Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
>
_________________________________
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
