Guys, 261x series routers do NOT have fast ethernet, NOR will they accept
ANY network module w/ a FE interface.
neither will 262x routers, whic have 1 or two FE interfaces built in.
the same goes for 265x. one or two built in, but it it not possible to add
more.
i am assuming from your description that there is another router in your
network on that switch.
if this is a true L3 switch, than your 2610 is NOT capable of being an MLS
RP and there must be another one on the network somewhere.
your routers eth. interface will plug into a single VLAN, with an IP route
either static or dynamic to those other VLANs via a next hop, the MLS RP on
your layer three switch.
this is quite fundamental. is there an entry for the network you are trying
to reach in your routing table.
I'm goign to take a wild guess here and assume that there is not yet.
tell us what kind of "L3 switch" you are using i need to know what equipment
you have, exactly, in this case, in order to help you.
i do not think that this is a default route probllem at all.
he is not supposed to be trunking to the switch, he should in this case have
a next hop on the VLAN that is connected to other VLANS, if this is a L3
switching scenario.
I also think that what he thinks is a layer 3 switch is not capable of
acting as one, or is not configured correctly.
Kiran, tell us what equipment you have, and what network connections you
have.
-Peter
-----Original Message-----
From: Patrick Ramsey [mailto:[EMAIL PROTECTED]]
Sent: Tuesday, July 24, 2001 10:56 AM
To: [EMAIL PROTECTED]
Subject: Re: Problem with Fastethernet 2610 router [7:13497]
sounds like you have missed a default route on the 2610.
The 2610 will not be able to see any other vlans unless the vlan it is
plugged into has an ip address assigned to it acting as a "gateway". Then
you need to set that ip address as the 2610's default gateway. (or at least
specify a specific route to the other vlans)
If this is a router conencted to the internet, you would defiantely want to
keep the default gw out it's serial interface.
-Patrick
>>> "Kiran Kumar M" 07/24/01 10:27AM >>>
Hai,
I am facing a strange problem. I am using a cisco 2610 router in my
network. In that I am having one fastethernet, and 2 WIC2T . When I am
connecting to the L3 switch, it is able to ping to that particular VLAN,
and unable to ping to other VLANS or outside of that VLAN. If I use
another router with ethernet card (becuase I am not having another
ethernet card in first router), with the same setup it is able to
communicate with the outside world. So I concluded that it is not the
problem with L3 switch. I tried to find it on cisco site, but unable to
locate the solution.
Thanks in advance,
Kiran
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=13515&t=13497
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
