cAN U SEND YR CONFIGS
-----Original Message-----
From: Kiran Kumar M [mailto:[EMAIL PROTECTED]]
Sent: Tuesday, July 24, 2001 10:40 PM
To: Farhan Ahmed
Cc: [EMAIL PROTECTED]
Subject: RE: Problem with Fastethernet 2610 router [7:13497]
It is not at all the routing problem. Because it is perfectly working with
the same configuration with other router with out any changes.
Thanks,
Kiran
On Tue, 24 Jul 2001, Farhan Ahmed wrote:
> u need to setup static route in both direction u just put only 1 route to
> the 1st vlan u need more rotes in both direc
> on the other vlans u should have static routes to router via x
>
> -----Original Message-----
> From: Kiran Kumar M [mailto:[EMAIL PROTECTED]]
> Sent: Tuesday, July 24, 2001 10:28 PM
> To: [EMAIL PROTECTED]
> Subject: Re: Problem with Fastethernet 2610 router [7:13497]
>
>
> Thanks for your mail.
>
> No, the default route is already there. It is already defined in that
> router. Infact I just copied it from the working router.
>
> Thanks,
> Kiran
>
>
> On Tue, 24 Jul 2001, Patrick Ramsey wrote:
>
> > sounds like you have missed a default route on the 2610.
> >
> > The 2610 will not be able to see any other vlans unless the vlan it is
> plugged into has an ip address assigned to it acting as a "gateway". Then
> you need to set that ip address as the 2610's default gateway. (or at
least
> specify a specific route to the other vlans)
> >
> > If this is a router conencted to the internet, you would defiantely want
> to keep the default gw out it's serial interface.
> >
> > -Patrick
> >
> >
> > >>> "Kiran Kumar M" 07/24/01 10:27AM >>>
> > Hai,
> >
> > I am facing a strange problem. I am using a cisco 2610 router in my
> > network. In that I am having one fastethernet, and 2 WIC2T . When I am
> > connecting to the L3 switch, it is able to ping to that particular VLAN,
> > and unable to ping to other VLANS or outside of that VLAN. If I use
> > another router with ethernet card (becuase I am not having another
> > ethernet card in first router), with the same setup it is able to
> > communicate with the outside world. So I concluded that it is not the
> > problem with L3 switch. I tried to find it on cisco site, but unable to
> > locate the solution.
> >
> > Thanks in advance,
> > Kiran
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=13574&t=13497
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
