All, I have a question that may have several answers, I have tried a few with varying results and would just like to see if anyone else has any suggestions. We run a Large Telco Data Backbone, most of which has been run on OSPF and BGP. Our distribution and access layers contain layer three functionality. The first customer data MAN rings that were built used EIGRP, we now need to standardize these old network segments and migrate them to OSPF. This is not the hard part, what is difficult is reducing the size of Area 0 so that it remains stable. Summarization is the only way. However the ip addresses used were not continuous and the routed ring is far to large to use one area. How would you successfully summarize the address over multi-areas and reduce the size of the area 0 table.
Mark I Will post what we did later. Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=26091&t=26091 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]