I have 1 Port T1 CSU/DSU WAN Interface Card, some more problems I am facing are 1) when I am trying to give service-module t1 remote-loopback payload command with out any optional parameter it does not work and gives that incomplete command error.where as the V54 is optional parameter
2) this combination of command also does not work and gives format error. service-module t1 remote-loopback full alternate this both v54 and alternate are optional parameters as mentioned in the documentation. http://www.cisco.com/en/US/products/sw/iosswrel/ps1835/products_command_reference_chapter09186a00800874e6.html#1019309 Please refer this link that these are optional parameters(v54 and alternate). In my knowledge there could be 4 possible combinations but only two work full full with alternate(doesnot work) payload(doesnot work) payload with v54 Can anybody explain these also in additional to the previous doubts mentioned below --------------------------------------------------- Simmi Singh wrote: > > Hi all, > while configuring the T1 CSU DSU card we use service-module > commands. > Here when I have the following command > service-module t1 remote-loopback {full | payload} [alternate | > v54] > The default option is Full and payload loopbacks with > standard-loopup codes. and its mentioned in documentation also > that by entering the service-module t1 remote-loopback command > without specifying any keywords, you enable the standard-loopup > codes, which use a 1-in-5 pattern for loopup and a 1-in-3 > pattern for loopdown. > > > The calrifications needed are that > 1) What is thedefault option for loopback.If I select the full option from the cli then want to switch > back to the default option, do the above command without > parameters will do that function > example > service-module t1 remote-loopback full alternate > > > then if i want to switch to default option will this work > > service-module t1 remote-loopback > > But I tried this command doesnot work(incomplete command) > so how to enable both payload and alternate with standard > loopup codes. > Just by negating the earlier command > is their some command for this > > 2) For what this default option used for > > any help will be appreciated Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=62539&t=62445 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
