Hi Dave Thanx replying is this in version 2 of WIC-1DSU-T1 these commands work fine or what I could not get u. May be somebody else who has worked on WIC-1DSU-T1,please do send your valuable comments if u have any.
MADMAN wrote: > > The documentation is not very accurate on this as you have > discovered. Thanks for pointing this out, I am beta testing > a version > 2 of the WIC-1DSU-T1 and it is not optional, I will pass this > on. > > Aside from testing though I have never needed to change the > default > in the real world. The defaults let you loop the CSU with a > standard > issue T-BERD. > > Dave > > Simmi Singh wrote: > > I have 1 Port T1 CSU/DSU WAN Interface Card, > > some more problems I am facing are > > 1) when I am trying to give > > service-module t1 remote-loopback payload command with out > any optional > > parameter it does not work and gives that incomplete command > error.where as > > the V54 is optional parameter > > > > 2) this combination of command also does not work and gives > format error. > > service-module t1 remote-loopback full alternate > > > > this both v54 and alternate are optional parameters as > mentioned in the > > documentation. > > > > > http://www.cisco.com/en/US/products/sw/iosswrel/ps1835/products_command_reference_chapter09186a00800874e6.html#1019309 > > > > Please refer this link that these are optional parameters(v54 > and > > alternate). > > In my knowledge there could be 4 possible combinations but > only two work > > > > full > > full with alternate(doesnot work) > > payload(doesnot work) > > payload with v54 > > > > Can anybody explain these also in additional to the previous > doubts > > mentioned below > > --------------------------------------------------- > > > > > > Simmi Singh wrote: > > > >>Hi all, > >>while configuring the T1 CSU DSU card we use service-module > >>commands. > >>Here when I have the following command > >>service-module t1 remote-loopback {full | payload} [alternate > | > >>v54] > >>The default option is Full and payload loopbacks with > >>standard-loopup codes. and its mentioned in documentation > also > >>that by entering the service-module t1 remote-loopback > command > >>without specifying any keywords, you enable the > standard-loopup > >>codes, which use a 1-in-5 pattern for loopup and a 1-in-3 > >>pattern for loopdown. > >> > >> > >>The calrifications needed are that > >>1) What is thedefault option for loopback.If I select the > full option from > > > > the cli then want to switch > > > >>back to the default option, do the above command without > >>parameters will do that function > >>example > >>service-module t1 remote-loopback full alternate > >> > >> > >>then if i want to switch to default option will this work > >> > >>service-module t1 remote-loopback > >> > >>But I tried this command doesnot work(incomplete command) > >>so how to enable both payload and alternate with standard > >>loopup codes. > >>Just by negating the earlier command > >>is their some command for this > >> > >>2) For what this default option used for > >> > >>any help will be appreciated > -- > David Madland > CCIE# 2016 > Sr. Network Engineer > Qwest Communications > 612-664-3367 > > "You don't make the poor richer by making the rich poorer." > --Winston > Churchill > > Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=62553&t=62445 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]