Yes, I have. -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] Behalf Of Neil Arlante Sent: 13 March 2003 19:14 To: [EMAIL PROTECTED] Subject: Re: ISDN Config Problem? [7:65315]
have u generated interesting traffic? ping to remote site. ----- Original Message ----- From: "Johan Bornman" To: Sent: Thursday, March 13, 2003 11:52 PM Subject: ISDN Config Problem? [7:65315] > I am having difficulty getting my Cisco 803 to dial out the BRI interface. > If I run the debug > commands: isdn q921 and q931 with the debug ppp authentication commands, > nothing happens. I have > also tried different configurations but I get the same from the > router.....nothing. Term mon is > enabled! The isdn status command shows the line as active or activated, so > there is no problem with > the line. I have tried the router on different ISDN lines to be sure. > > How do I check if my BRI interface is working? > > Any feedback/suggestions will be appreciated. > > Regards > > Johan > > > > Here is my config: (I have x'd out the username, password and dialer string > number) > > CSTM#sh run > Building configuration... > > Current configuration : 1020 bytes > ! > version 12.1 > no service pad > service timestamps debug uptime > service timestamps log uptime > no service password-encryption > ! > hostname CSTM > ! > enable secret 5 $1$9Y0j$fCPvbvNR8L37mwYBtD66K0 > ! > ip subnet-zero > ! > no ip domain-lookup > no ip finger > isdn switch-type basic-net3 > ! > interface Ethernet0 > ip address 192.168.3.250 255.255.255.0 > ip nat inside > ! > interface BRI0 > no ip address > ip nat outside > encapsulation ppp > dialer pool-member 1 > isdn switch-type basic-net3 > no cdp enable > ! > interface Dialer0 > ip address negotiated > encapsulation ppp > dialer pool 1 > dialer idle-timeout 300 > dialer string XXXXXXXXXXX > dialer load-threshold 128 outbound > dialer-group 1 > ppp pap sent-username XXXXXXXXXX password 7 XXXXXXXXXXXXX > ! > ip nat inside source list 1 interface BRI0 overload > no ip http server > ip classless > ip route 0.0.0.0 0.0.0.0 Dialer0 > ! > access-list 1 permit 0.0.0.0 255.255.255.0 > dialer-list 1 protocol ip permit > ! > line con 0 > transport input none > stopbits 1 > line vty 0 4 > password cstm > login > ! Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=65394&t=65315 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]