Congrats on launch. The sideways propwalk is normal, and will be slightly different at different RPMS. At full cruising Revs, Resolute needs a half spoke of wheel to steer straight. I seem to have to relearn that each spring. My wheel is marked w different colored tape, so I know where centered is.
Chuck Resolute 1990 C&C 34R Broad Creek, Magothy River, Md ----- Original Message ----- From: "CNC boat owners, cnc-list" <cnc-list@cnc-list.com> To: "CNC boat owners, cnc-list" <cnc-list@cnc-list.com> Sent: Saturday, June 21, 2014 2:57:10 PM Subject: Re: Stus-List Launch I am pleased to report that the boat has been launched and that the launch went smoothly; the engine (Yanmar 3HM) fired right up and has plenty of power in reverse, (2 blade fixed prop); the only thing I wasn't ready for was, when under power, there is a steady pull to port, like when a car is out of alignment; is this a normal thing or should I be looking for some adjustment? Tomorrow we hoist the sails! It is reaalllly nice to be back on the water, 93 degrees and all! Richard 1985 37 CB Ohio River Mile 600 2950 Breckenridge Lane, Suite Nine Louisville, Kentucky 40220-1462 502-584-7255 _______________________________________________ This List is provided by the C&C Photo Album Email address: CnC-List@cnc-list.com To change your list preferences, including unsubscribing -- go bottom of page at: http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com _______________________________________________ This List is provided by the C&C Photo Album Email address: CnC-List@cnc-list.com To change your list preferences, including unsubscribing -- go bottom of page at: http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com
_______________________________________________ This List is provided by the C&C Photo Album Email address: CnC-List@cnc-list.com To change your list preferences, including unsubscribing -- go bottom of page at: http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com