Jason Dyer wrote:
>
> ----- Original Message -----
> From: "Robert Fox" <[EMAIL PROTECTED]>
> To: <[EMAIL PROTECTED]>
> Sent: Sunday, September 09, 2001 4:59 AM
> Subject: Re: [Cooker] Mandrake 8.1 Beta 3
>
> > I also have an A7V with and AMD 850 inside . . .
> >
> > I have two HDs (30 gig ATA100 on the Promise ATA controller) and a 20
> > gig on the onboard controller. I boot from the Promise controller and
> > Linus runs off the Promise alongside Win98 and Win2K.
> >
> > I had the same problem after an install that when the system reboots, I
> > get only "LI"
> >
> > The trick after the install is to boot to the rescue disk (boot medium
> > like CDROM or floppy and type F1 at the Linux: prompt - then type
> > "rescue" and hit return.)
> >
> > When it boots and you get to the bash prompt, type "chroot /mnt" and
> > then edit your /etc/lilo.conf file (using your favorite editor) and add
> > the following lines after the keytable entry:
> >
> > disk=/dev/hde
> > bios=0x80
> >
> > if you have another drive under the onboard controller like me add also:
> >
> > disk=/dev/hda
> > bios=0x81
>
> Is that an on-board raid controller? Can you see the raid drives from
> linux?? I have a similar setup, but basically gave up on seeing the raid
> disks...
>
> -Jason
with beta 2 on my Abit KT7-Raid Motherboard I saw the two drives that
were installed and not the raid drive.
Greg
