On 7/1/2012 10:35 AM, KU4AF wrote: > The idea is to let the macro itself reassign > the PF key to a different macro. For example, say you want the PF2 key to > toggle between setting VFO A to 14010 and 14020 (not useful but just an > example).
Vaguely reminiscent of very early stored program computers where it was considered a cool feature that your code could do arithmetic on itself creating new code the next time through [like stepping an address sequentially, or ... gasp ... changing instruction op codes into different instructions :-)]. I have yet to figure out how to get N1MM to use both banks of the K3 DVR. The obvious way would be for the macros that use Bank 2 make the switch and key the message and then switch back to Bank 1. The problem is that the logger has no way of knowing when the voice message is over. It does the bank switch OK and keys the message, then executes the switch back to Bank 1 killing the audio immediately. I guess this is the case for all loggers since there's no feedback from the K3 DVR that it's done. I've never needed more than two messages on SSB, so it isn't a problem, just a challenge. 73, Fred K6DGW - Northern California Contest Club - CU in the 2012 Cal QSO Party 6-7 Oct 2012 - www.cqp.org ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html