In final stages of building KIO2 interface .... Am doing Serial Interface Test .... Using HyperTeminal, I am indeed able to issue the suggested command, SH01; which causes a band increment. However, communication in the opposite direction is nonexistent; that is, following the procedure on page 14 to issue the Test Message from the K2 causes no response on Hyperterminal.
Any suggestions are, of course, deeply appreciated and welcome. ------------------------------------------------------------------------------- This email message, including any attachments, is for the sole use of the intended recipient(s) and may contain information that is proprietary, confidential, and exempt from disclosure under applicable law. Any unauthorized review, use, disclosure, or distribution is prohibited. If you have received this email in error please notify the sender by return email and delete the original message. Please note, the recipient should check this email and any attachments for the presence of viruses. The organization accepts no liability for any damage caused by any virus transmitted by this email. ==============================================================================
_______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
