Thanks Roger, that information is rewarding.
Imagine what would happen if a power outage occurs during a firmware
upload. The odds are slim, but my middle name is 'Murphy'.
I want a good battery in my laptop as well. It has to finish the upload.
Dick, n0ce
On 12/23/2014 10:09 AM, Roger D Johnson wrote:
It IS possible to send the K3 off to never-never land by removing the
12 volt input before
shutting the radio off with the power switch. I've had it happen
whilst mucking around
behind my desk and accidentally pulling out the Anderson power-pole
connector.
If you've saved the settings using the K3 utility, you can reset
everything using the
procedure on page 63 of the K3 manual. NOTE: This did not work with my
rotor
control plugged into the ACC socket! If you didn't save the
parameters, you will
have to manually reset everything! SAVE!
73, Roger
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to arch...@mail-archive.com