It IS possible to send the K3 off to never-never land by removing the 12 volt
input before
shutting the radio off with the power switch. I've had it happen whilst mucking
around
behind my desk and accidentally pulling out the Anderson power-pole connector.
If you've saved the settings using the K3 utility, you can reset everything
using the
procedure on page 63 of the K3 manual. NOTE: This did not work with my rotor
control plugged into the ACC socket! If you didn't save the parameters, you will
have to manually reset everything! SAVE!
73, Roger
On 12/23/2014 1:30 AM, Richard Fjeld wrote:
Well, more good information. Maybe I stand corrected. It's been nearly 4
years since I have read the manual, and my memory may have read more into the
statements than it should have.
I refer to page 13, right hand column, halfway down, entitled "POWER". There
is a note that reads "To ensure correct save of operating parameters, turn the
K3 off /before/ turning the power supply off." When I read that, I thought
about the short duration power failures we experience.
______________________________________________________________
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to arch...@mail-archive.com
