This is on the issues list already. The change will be to have 100 Hz steps below 3.0 kHz and 200 Hz steps above that.
73 Greg AB7R -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] Behalf Of Toby Deinhardt Sent: Tuesday, February 05, 2008 2:11 PM To: G4ILO Cc: elecraft@mailman.qth.net Subject: Re: [Elecraft] K3 SSB width control > probably can't tell the difference between 2.6 and 2.7 so it's no real > hardship to keep the DSP 100z narrower, but it's a bit of a niggle. It's rather simple - above 2kHz the K3 uses 200Hz steps and below 2kHz steps of 100Hz. If you tune down from 2.7kHz: 2700, 2500, 2300, 2100, etc. If you tune up from 1.8kHz: 1800, 1900, 2000, 2200, 2400, 2600, etc. vy 73 de toby _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
