Hard to make a shielded room without walls. Cortland Richmond KA5S (opinions mine,not my employer's)
On 8/30/2011 4:52 AM, rehel...@mmm.com wrote: And Figures 2 and 3 of the Figures 1 through 5 clearly show a vertical back plane with the tabletop horizontal ground plane bonded to it (or at least it implies a vertical back plane). It is either a vertical back plane or the floor back plane bent up at a 90 degree angle. If there wasn't any confusion since 1993 then there should have been. : ) The equipment I have is tabletop equipment to be mounted below the water line (i.e., below deck). The reference is to Figures 1 through 5 (all of them), not just Figure 1. Bob Heller St. Paul, MN 55107-1208 Tel: 651-778-6336 Fax: 651-778-6252 ================================= - ---------------------------------------------------------------- This message is from the IEEE Product Safety Engineering Society emc-pstc discussion list. To post a message to the list, send your e-mail to <emc-p...@ieee.org> All emc-pstc postings are archived and searchable on the web at http://product-compliance.oc.ieee.org/ Graphics (in well-used formats), large files, etc. can be posted to that URL. Website: http://www.ieee-pses.org/ Instructions: http://listserv.ieee.org/request/user-guide.html List rules: http://www.ieee-pses.org/listrules.html For help, send mail to the list administrators: Scott Douglas <emcp...@radiusnorth.net> Mike Cantwell <mcantw...@ieee.org> For policy questions, send mail to: Jim Bacher <j.bac...@ieee.org> David Heald <dhe...@gmail.com>