On Sat, 2007-12-08 at 20:26 +0000, Alan Condit wrote: > My working ini and hal files are derived from stepper_in.ini and > xylotex_pinout.hal and those files are considerably different from the files > generated by stepconf. On the hal files diff basically doesn't find any common > lines to anchor on.
Yes. This will be an issue until we decide to make stepconfig versions of the types of machines for which it was written. I tried using the HAL save stuff but it produced files that were so much different from the hand written ones that I figured I'd confuse things badly. No solution here except to say that perhaps 2.3 ought to supply configs made with the configurator. Rayh ------------------------------------------------------------------------- SF.Net email is sponsored by: Check out the new SourceForge.net Marketplace. It's the best place to buy or sell services for just about anything Open Source. http://sourceforge.net/services/buy/index.php _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
