Hi, The MPG jog wheels I sell have differential outputs.
http://homanndesigns.com/store/index.php?main_page=index&cPath=15 That is A+, A-,B+,B-. The - outputs have the complement of the + signal on them. You can use them as single ended inputs by ignoring the A-, B- outputs and just use the A+, B+ outputs. Cheers, Peter. [EMAIL PROTECTED] wrote: > Hi > I have provlem with www.CNC4PC. > ehere is those company? > Are they in USA or where? > Every US company has a phone to call and ask questions CNC4PS doesn't. > i send e-mail with same question and he send me phone 772-6215525 number > but nobody answer those phone. > Does any one purchased any think from cnc4pc? > thanks > Aram > > > > >>> When it comes to electronics I need all the help I can get. So the MPG >>> puts out 4 >>> pairs of signals and the LM399 converts that to 4 outputs? Lots of >>> googling going >>> on... and EMC needs? I'm just looking at a MPG spec sheet and they only >>> have 6 >>> connections so I assume one is ground, one is power in and the other 4 >>> are the >>> signal coming out. Now I'm really confused. The LM399 has 8 inputs and 4 >>> outputs. >>> Can you explain just a bit more for me please. >> The cnc4pc jogwheel has A and B outputs ('single-ended' if you like). >> These plug directly into the A and B channels of a hardware encoder >> counter (m5i20, pico-systems, vital, etc.). >> If you don't have a spare encoder input the jog-wheel could be read by >> two general purpose I/O pins (e.g. parallel port) since you are not >> likely to spin the jogwheel very fast. >> >> Some jogwheels use differential signals, which means instead of just the >> A and B signals you get A+, A-, B+, and B-. If you have I/O to spare you >> could wire all four of these to EMC. If you want to condense these four >> into just two A and B signals you can do that with an IC. I did that >> with a DS3486. >> >> >> AW >> >> ------------------------------------------------------------------------- >> Check out the new SourceForge.net Marketplace. >> It's the best place to buy or sell services for >> just about anything Open Source. >> http://ad.doubleclick.net/clk;164216239;13503038;w?http://sf.net/marketplace >> _______________________________________________ >> Emc-users mailing list >> Emc-users@lists.sourceforge.net >> https://lists.sourceforge.net/lists/listinfo/emc-users >> > > > > ------------------------------------------------------------------------- > Check out the new SourceForge.net Marketplace. > It's the best place to buy or sell services for > just about anything Open Source. > http://ad.doubleclick.net/clk;164216239;13503038;w?http://sf.net/marketplace > _______________________________________________ > Emc-users mailing list > Emc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-users > > -- ------------------------------------------------------------------ Web: www.homanndesigns.com email: [EMAIL PROTECTED] Phone: +61 421 601 665 www.homanndesigns.com/ModIO.html - Modbus Interface Unit www.homanndesigns.com/DigiSpeedDeal.html - DC Spindle control www.homanndesigns.com/TurboTaig.html - Taig Mill Upgrade board ------------------------------------------------------------------------- Check out the new SourceForge.net Marketplace. It's the best place to buy or sell services for just about anything Open Source. http://ad.doubleclick.net/clk;164216239;13503038;w?http://sf.net/marketplace _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users