How do you set the tolerance of G64.... It won't solve the problem of my text falling down though, will it? Aaron > ----- Original Message ----- > From: "Anders Wallin" <[EMAIL PROTECTED]> > To: "Enhanced Machine Controller (EMC)" <emc-users@lists.sourceforge.net> > Subject: Re: [Emc-users] Micro stepper driver MSD542 / KL-5042 > Date: Mon, 19 May 2008 19:30:33 +0300 > > > > For the different trajectory modes see: > http://wiki.linuxcnc.org/cgi-bin/emcinfo.pl?TrajectoryControl > > If using only G64, many people report that the trajectory 'cuts-corners' > either too much (you get rounded off corners) or too little (contouring > programs run very slow). > > Therefore I'd suggest a tolerance is always used with G64, for example > G64P0.01 for a tolerance of 0.01 mm (if you program in mm) > > > I do not know the answers to these questions. I come at this as a > > woodworker with no cnc experience to speak of. I was hoping to > > use the stepconfig wizard, but this only works occasionally > >> > >> Are you using G64 ? If so, what tolerance are you using: G64PX.XX > >> > > ------------------------------------------------------------------------- > This SF.net email is sponsored by: Microsoft > Defy all challenges. Microsoft(R) Visual Studio 2008. > http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ > _______________________________________________ > Emc-users mailing list > Emc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-users
> -- Powered by Outblaze ------------------------------------------------------------------------- This SF.net email is sponsored by: Microsoft Defy all challenges. Microsoft(R) Visual Studio 2008. http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
