Gentlemen, I was just made aware of a recurring problem with the Cinci and the Enshu. I have heard nothing about the Dahlih. The Enshu is running 2.5.0-pre and Touchy interface. The Cinci is running 2.5.0-pre and Axis interface. Yesterday the Enshu lost Y position during a program run. The Cinci has done this previously but that was before the latest update to 10.04 and 2.5.0-pre. I did not report anything when the Cinci lost position because I could not be certain the problem was not mechanical. I am not CERTAIN the problem is not mechanical now but on two machines I have the same symptom. This leads me to want to report this. On the Enshu the Y position was incorrect by approximately .400 inch in the middle of the tool motion. Some correct cuts were made and then the tool plunged into the part in an incorrect position. Sending the machine to Y0 showed the misposition in the program zero. Homing the machine corrected the error. The same error repeated a little later yesterday during the run of a different part program. This time the error was in the opposite direction of the previous error. Again, homing the machine corrected the error. We have only seen this happen on the Y axis on both machines. Questions will be investigated/answered to the best of my ability. thanks Stuart
-- dos centavos ------------------------------------------------------------------------------ Forrester Wave Report - Recovery time is now measured in hours and minutes not days. Key insights are discussed in the 2010 Forrester Wave Report as part of an in-depth evaluation of disaster recovery service providers. Forrester found the best-in-class provider in terms of services and vision. Read this report now! http://p.sf.net/sfu/ibm-webcastpromo _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
